SAM3X8E Atmel Corporation, SAM3X8E Datasheet - Page 541

• Manufacturer Part Number: SAM3X8E
• Manufacturer: Atmel Corporation

28.2
28.2.1
28.2.2
11057A–ATARM–17-Feb-12
11057A–ATARM–17-Feb-12
Power Management Controller (PMC)
Description
Embedded Characteristics
The Power Management Controller (PMC) optimizes power consumption by controlling all sys-
tem and user peripheral clocks. The PMC enables/disables the clock inputs to many of the
peripherals and the Cortex-M3 Processor.
The Supply Controller selects between the 32 kHz RC oscillator or the crystal oscillator. The
unused oscillator is disabled automatically so that power consumption is optimized.
By default, at startup the chip runs out of the Master Clock using the Fast RC oscillator running
at 4 MHz.
The user can trim the 8 and 12 MHz RC Oscillator frequencies by software.
The Power Management Controller provides the following clocks:
Programmable Clock Outputs can be selected from the clocks provided by the clock generator
and driven on the PCKx pins.
The Power Management Controller also provides the following operations on clocks:
• MCK, the Master Clock, programmable from a few hundred Hz to the maximum operating
• Processor Clock (HCLK) is automatically switched off when the processor enters Sleep
• Free running processor Clock (FCLK)
• the Cortex-M3 SysTick external clock
• UDP Clock (UDPCK), required by USB Device Port operations.
• Peripheral Clocks, typically MCK, provided to the embedded peripherals (USART, SSC, SPI,
• a main crystal oscillator clock failure detector.
• a frequency counter on main clock .
frequency of the device. It is available to the modules running permanently, such as the
Enhanced Embedded Flash Controller.
Mode.
TWI, TC, HSMCI, etc.) and independently controllable. Some of the peripherals can be
configured to be driven by MCK divided by 2, 4.In order to reduce the number of clock names
in a product, the Peripheral Clocks are named MCK in the product datasheet.
SAM3X/A
SAM3X/A
541
541