ST72344S4 STMicroelectronics, ST72344S4 Datasheet - Page 199

• Manufacturer Part Number: ST72344S4
• Description: 8-bit MCU
• Manufacturer: STMicroelectronics

Specifications of ST72344S4

• Up To 16 Kbytes Program Memory: single voltage extended Flash (XFlash) with readout and write protection, in-circuit and inapplication programming (ICP and IAP). 10K write/erase cycles guaranteed, data retention
• 256 Bytes Data Eeprom With Readout Protection. 300k Write/erase Cycles Guaranteed, Data Retention: 20 years at 55 °C.
• Clock Sources: crystal/ceramic resonator oscillators, high-accuracy internal RC oscillator or external clock
• 5 Power-saving Modes: Slow, Wait, Halt, Auto-wakeup from Halt and Active-halt
• 16-bit Timer A With: 1 input capture, 1 output compares, external clock input, PWM and pulse generator modes
• 16-bit Timer B With: 2 input captures, 2 output compares, PWM and pulse generator modes

ST72344xx ST72345xx
13
13.1
13.1.1
13.1.2
13.1.3
13.1.4
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
4.5 V ≤ V
They are given only as design guidelines and are not tested.
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Figure 85. Pin loading conditions
DD
≤ 5.5 V voltage range) and V
Doc ID 12321 Rev 5
C
L
DD
= 3.3 V (for the 3 V ≤ V
ST7 PIN
A
=25°C and T
A
SS
= 25 °C, V
.
Electrical characteristics
DD
DD
A
≤ 3.6 V voltage range).
=T
= 5 V (for the
A
max (given by the
Figure
85.
199/247