at32uc3b0512-z2ues ATMEL Corporation, at32uc3b0512-z2ues Datasheet - Page 452
at32uc3b0512-z2ues
Manufacturer Part Number
at32uc3b0512-z2ues
Description
32-bit Avr Microcontroller
Manufacturer
ATMEL Corporation
Datasheet
1.AT32UC3B0512-Z2UES.pdf
(680 pages)
- Current page: 452 of 680
- Download datasheet (10Mb)
•
•
•
32059J–12/2010
LDNXTCHDES
BUFFCLOSEINEN: Buffer Close Input Enable
LDNXTCHDESCEN: Load Next Channel Descriptor Enable
CHEN: Channel Enable
CEN
For Bulk and Interrupt endpoint, writing a one to this bit will automatically close the current DMA transfer at the end of the USB
For Full-speed Isochronous, it does not make sense, so BUFFCLOSEINEN should be left to zero.
Writing a zero to this bit to disable this feature.
1: the channel controller loads the next descriptor after the end of the current transfer, i.e. when the UDDMAnSTATUS.CHEN bit
0: no channel register is loaded after the end of the channel transfer.
If the CHEN bit is written to zero, the next descriptor is immediately loaded upon transfer request (endpoint is free for IN
Writing this bit to zero will disabled the DMA channel and no transfer will occur upon request. If the LDNXTCHDESCEN bit is
Writing this bit to one will set the UDDMAnSTATUS.CHEN bit and enable DMA channel data transfer. Then any pending request
This bit is cleared when the channel source bus is disabled at end of buffer. If the LDNXTCHDESCEN bit has been cleared by
If a channel request is currently serviced when this bit is zero, the DMA FIFO buffer is drained until it is empty, then the
If the LDNXTCHDESCEN bit is set or after this bit clearing, then the currently loaded descriptor is skipped (no data transfer
0
0
1
1
OUT data transfer (received short packet).
is reset.
endpoint, or endpoint is full for OUT endpoint).
written to zero, the channel is frozen and the channel registers may then be read and/or written reliably as soon as both
UDDMAnSTATUS.CHEN and CHACTIVE bits are zero.
will start the transfer. This may be used to start or resume any requested transfer.
descriptor loading, the user will have to write to one the corresponding CHEN bit to start the described transfer, if needed.
UDDMAnSTATUS.CHEN bit is cleared.
occurs) and the next descriptor is immediately loaded.
CHEN
Table 22-6.
0
1
0
1
Current Bank
stop now
Run and stop at end of buffer
Load next descriptor now
Run and link at end of buffer
DMA Channel Control Command Summary
AT32UC3B
452
Related parts for at32uc3b0512-z2ues
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
AM-FM Receiver IC U4255BM-M
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Monolithic Integrated Feature Phone Circuit
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Multistandard Video-IF and Quasi Parallel Sound Processing
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
High-performance EE PLD
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
8-bit Flash Microcontroller
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
2-Wire Serial EEPROM
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
U6046BREAR WINDOW HEATING TIMER / LONG-TERM TIMER
Manufacturer:
ATMEL Corporation
Datasheet: