mc9s08dz32amlfr Freescale Semiconductor, Inc, mc9s08dz32amlfr Datasheet - Page 148

• Manufacturer Part Number: mc9s08dz32amlfr
• Description: Hcs08 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

Chapter 7 Central Processor Unit (S08CPUV5)
the high-order byte is located in the next memory location after the opcode, and the low-order byte is
located in the next memory location after that.
7.3.4
In direct addressing mode, the instruction includes the low-order eight bits of an address in the direct page
(0x0000–0x00FF). During execution a 16-bit address is formed by concatenating an implied 0x00 for the
high-order half of the address and the direct address from the instruction to get the 16-bit address where
the desired operand is located. This is faster and more memory efficient than specifying a complete 16-bit
address for the operand.
7.3.5
In extended addressing mode, the full 16-bit address of the operand is located in the next two bytes of
program memory after the opcode (high byte first).
7.3.6
Indexed addressing mode has seven variations including five that use the 16-bit H:X index register pair and
two that use the stack pointer as the base reference.
7.3.6.1
This variation of indexed addressing uses the 16-bit value in the H:X index register pair as the address of
the operand needed to complete the instruction.
7.3.6.2
This variation of indexed addressing uses the 16-bit value in the H:X index register pair as the address of
the operand needed to complete the instruction. The index register pair is then incremented
(H:X = H:X + 0x0001) after the operand has been fetched. This addressing mode is only used for MOV
and CBEQ instructions.
7.3.6.3
This variation of indexed addressing uses the 16-bit value in the H:X index register pair plus an unsigned
8-bit offset included in the instruction as the address of the operand needed to complete the instruction.
7.3.6.4
This variation of indexed addressing uses the 16-bit value in the H:X index register pair plus an unsigned
8-bit offset included in the instruction as the address of the operand needed to complete the instruction.
The index register pair is then incremented (H:X = H:X + 0x0001) after the operand has been fetched. This
addressing mode is used only for the CBEQ instruction.
148
Direct Addressing Mode (DIR)
Extended Addressing Mode (EXT)
Indexed Addressing Mode
Indexed, No Offset (IX)
Indexed, No Offset with Post Increment (IX+)
Indexed, 8-Bit Offset (IX1)
Indexed, 8-Bit Offset with Post Increment (IX1+)
MC9S08DZ128 Series Data Sheet, Rev. 1
Freescale Semiconductor