MC56F8367EVME Freescale Semiconductor, MC56F8367EVME Datasheet - Page 18

• Manufacturer Part Number: MC56F8367EVME
• Description: EVAL BOARD FOR MC56F83X
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8367EVME

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC56F8145-67 and MC56F8345-67
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F83xx
• Rohs Compliant: Yes
• For Use With/related Products: MC56F83x5, MC56F83x6, MC56F83x7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.2 Signal Pins
After reset, each pin is configured for its primary function (listed first). Any alternate functionality must
be programmed.
Note: Signals in italics are NOT available in the 56F8167 device.
Note: The 160 Map Ball Grid Array is not available in the 56F8167 device.
If the “State During Reset” lists more than one state for a pin, the first state is the actual reset state. Other
states show the reset condition of the alternate function, which you get if the alternate pin function is
selected without changing the configuration of the alternate peripheral. For example, the A8/GPIOA0 pin
shows that it is tri-stated during reset. If the GPIOA_PER is changed to select the GPIO function of the
pin, it will become an input if no other registers are changed.
Note: LQFP Pin numbers and MBGA Ball numbers do not always correlate in Table 2-2. Please contact
factory for exact correlation.
18
V
V
DDA_OSC_
DDA_ADC
V
V
V
V
V
V
V
Signal
Name
DD_IO
DD_IO
DD_IO
DD_IO
DD_IO
DD_IO
DD_IO
PLL
Table 2-2 Signal and Package Information for the 160-Pin LQFP and MBGA
No.
134
114
Pin
16
31
42
77
96
92
1
Ball No.
C14
K10
F11
K13
F4
K5
E5
K7
E9
Supply
Supply
Supply
Type
56F8367 Technical Data, Rev. 8
During
Reset
State
I/O Power — This pin supplies 3.3V power to the chip I/O
interface and also the Processor core through the on-chip voltage
regulator, if it is enabled.
ADC Power — This pin supplies 3.3V power to the ADC modules.
It must be connected to a clean analog power supply.
Oscillator and PLL Power — This pin supplies 3.3V power to the
OSC and to the internal regulator that in turn supplies the Phase
Locked Loop. It must be connected to a clean analog power
supply.
Signal Description
Freescale Semiconductor
Preliminary