MC56F8367EVME Freescale Semiconductor, MC56F8367EVME Datasheet - Page 31

• Manufacturer Part Number: MC56F8367EVME
• Description: EVAL BOARD FOR MC56F83X
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8367EVME

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC56F8145-67 and MC56F8345-67
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F83xx
• Rohs Compliant: Yes
• For Use With/related Products: MC56F83x5, MC56F83x6, MC56F83x7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Freescale Semiconductor
Preliminary
Table 2-2 Signal and Package Information for the 160-Pin LQFP and MBGA (Continued)
(GPIOE5)
(GPIOE6)
(GPIOE7)
MOSI0
MISO0
Signal
Name
SS0
No.
148
147
145
Pin
Ball No.
D4
D5
B6
Output
Output
Output
Output
Output
Input/
Input/
Input/
Input/
Input/
Type
Input
56F8367 Technical Data, Rev. 8
disabled,
pull-up is
output is
In reset,
enabled
enabled
enabled
During
pull-up
pull-up
Reset
State
Input,
Input,
SPI 0 Master Out/Slave In — This serial data pin is an output
from a master device and an input to a slave device. The master
device places data on the MOSI line a half-cycle before the clock
edge the slave device uses to latch the data.
Port E GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is MOSI0.
To deactivate the internal pull-up resistor, clear bit 5 in the
GPIOE_PUR register.
SPI 0 Master In/Slave Out — This serial data pin is an input to a
master device and an output from a slave device. The MISO line
of a slave device is placed in the high-impedance state if the slave
device is not selected. The slave device places data on the MISO
line a half-cycle before the clock edge the master device uses to
latch the data.
Port E GPIO — This GPIO pin can be individually programmed as
an input or output pin.
After reset, the default state is MISO0.
To deactivate the internal pull-up resistor, clear bit 6 in the
GPIOE_PUR register.
SPI 0 Slave Select — SS0 is used in slave mode to indicate to
the SPI module that the current transfer is to be received.
Port E GPIO — This GPIO pin can be individually programmed as
input or output pin.
After reset, the default state is SS0.
To deactivate the internal pull-up resistor, clear bit 7 in the
GPIOE_PUR register.
Signal Description
Signal Pins
31