MC56F8367EVME Freescale Semiconductor, MC56F8367EVME Datasheet - Page 33

• Manufacturer Part Number: MC56F8367EVME
• Description: EVAL BOARD FOR MC56F83X
• Manufacturer: Freescale Semiconductor
• Type: DSPr

Specifications of MC56F8367EVME

• Contents: Module and Misc Hardware
• Processor To Be Evaluated: MC56F8145-67 and MC56F8345-67
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: 56800/E
• Core Sub-architecture: 56800/E
• Silicon Core Number: MC56F
• Silicon Family Name: MC56F83xx
• Rohs Compliant: Yes
• For Use With/related Products: MC56F83x5, MC56F83x6, MC56F83x7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Freescale Semiconductor
Preliminary
Table 2-2 Signal and Package Information for the 160-Pin LQFP and MBGA (Continued)
(GPIOC2)
(GPIOC3)
(MISO1)
INDEX1
HOME1
Signal
Name
(TB2)
(TB3)
(SS1)
No.
Pin
8
9
Ball No.
E2
E1
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Schmitt
Output
Output
Output
Output
Output
Input/
Input/
Input/
Input/
Input/
Type
Input
Input
Input
56F8367 Technical Data, Rev. 8
enabled
enabled
During
pull-up
pull-up
Reset
State
Input,
Input,
Index1 — Quadrature Decoder 1, INDEX input
TB2 — Timer B, Channel 2
SPI 1 Master In/Slave Out — This serial data pin is an input to a
master device and an output from a slave device. The MISO line
of a slave device is placed in the high-impedance state if the slave
device is not selected. The slave device places data on the MISO
line a half-cycle before the clock edge the master device uses to
latch the data. To activate the SPI function, set the INDEX_ALT
bit in the SIM_GPS register. For details, see
Port C GPIO — This GPIO pin can be individually programmed
as an input or output pin.
In the 56F8367, the default state after reset is INDEX1.
In the 56F8167, the default state is not one of the functions
offered and must be reconfigured.
To deactivate the internal pull-up resistor, clear bit 2 in the
GPIOC_PUR register.
Home — Quadrature Decoder 1, HOME input
TB3 — Timer B, Channel 3
SPI 1 Slave Select — In the master mode, this pin is used to
arbitrate multiple masters. In slave mode, this pin is used to select
the slave. To activate the SPI function, set the HOME_ALT bit in
the SIM_GPS register. For details, see
Port C GPIO — This GPIO pin can be individually programmed
as an input or output pin.
In the 56F8367, the default state after reset is HOME1.
In the 56F8167, the default state is not one of the functions
offered and must be reconfigured.
To deactivate the internal pull-up resistor, clear bit 3 in the
GPIOC_PUR register.
Signal Description
Part
6.5.8.
Part
6.5.8.
Signal Pins
33