HD64F2612FA20 Renesas Electronics America, HD64F2612FA20 Datasheet - Page 538

• Manufacturer Part Number: HD64F2612FA20
• Description: IC H8S MCU FLASH 128K 80QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2612FA20

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 43
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 80-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 20 Power-Down Modes
20.8
20.8.1
In software standby mode, I/O port states are retained. Therefore, there is no reduction in current
dissipation for the output current when a high-level signal is output.
20.8.2
Current dissipation increases during the oscillation stabilization wait period.
20.8.3
Depending on the operating status of the DTC, MSTPA6 bit may not be set to 1. Setting of the
DTC module stop mode should be carried out only when the respective module is not activated.
For details, refer to section 8, Data Transfer Controller (DTC).
20.8.4
Relevant interrupt operations cannot be performed in module stop mode. Consequently, if module
stop mode is entered when an interrupt has been requested, it will not be possible to clear the CPU
interrupt source or the DTC activation source.
Interrupts should therefore be disabled before entering module stop mode.
20.8.5
MSTPCR should only be written to by the CPU.
Rev. 7.00 Sep. 11, 2009 Page 502 of 566
REJ09B0211-0700
Usage Notes
I/O Port Status
Current Dissipation during Oscillation Stabilization Wait Period
DTC Module Stop
On-Chip Supporting Module Interrupt
Writing to MSTPCR