HD64F7145F50 Renesas Electronics America, HD64F7145F50 Datasheet - Page 98

• Manufacturer Part Number: HD64F7145F50
• Description: IC SUPERH MCU FLASH 256K FP144F
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7144r

Specifications of HD64F7145F50

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: EBI/EMI, I²C, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 98
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

3. MCU Operating Modes
3.5
In the initial state of this LSI, some of on-chip modules are set in module standby state for saving
power. When operating these modules, clear module standby state according to the procedure in
section 24, Power-Down Modes.
3.6
When changing operating mode while power is applied to this LSI, make sure to do it in the
power-on reset state (that is, the low level is applied to the RES pin). In addition, when changing
clock mode, secure the reset oscillation stabilization time (t
Rev.4.00 Mar. 27, 2008 Page 52 of 882
REJ09B0108-0400
CK
MD3 to MD0
RES
Note on Changing Operating Mode
Initial State in This LSI
Notes:
Figure 3.2 Reset Input Timing when Changing Operating Mode
1.
2.
See section 26.3.3, Control Signal Timing.
See section 26.3.2, Clock Timing.
When changing other than clock mode
t
MDS
*
1
OSC1
) after clock mode change.
When changing clock mode
t
OSC1
*
2