AT32UC3A3128 Atmel Corporation, AT32UC3A3128 Datasheet - Page 385

• Manufacturer Part Number: AT32UC3A3128
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A3128

• Flash (kbytes): 128 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 110
• Ext Interrupts: 110
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Ssc: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Dac Channels: 2
• Dac Resolution (bits): 16
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 128
• Self Program Memory: YES
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 12
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

20.6
32072G–11/2011
User Interface
The GPIO controls all the I/O pins on the AVR32 microcontroller. The pins are managed as 32-
bit ports that are configurable through a PB interface. Each port has a set of configuration regis-
ters. The overall memory map of the GPIO is shown below. The number of pins and hence the
number of ports are product specific.
Figure 20-6. Overall Mermory Map
In the GPIO Controller Function Multiplexingtable in the Package and Pinout chapter, each
GPIO line has a unique number. Note that the PA, PB, PC and PX ports do not directly corre-
spond to the GPIO ports. To find the corresponding port and pin the following formula can be
used:
GPIO port = floor((GPIO number) / 32), example: floor((36)/32) = 1
GPIO pin = GPIO number mod 32, example: 36 mod 32 = 4
The table below shows the configuration registers for one port. Addresses shown are relative to
the port address offset. The specific address of a configuration register is found by adding the
Port 0 Configuration Registers
Port 1 Configuration Registers
Port 2 Configuration Registers
Port 3 Configuration Registers
Port 4 Configuration Registers
0x0000
0x0100
0x0200
0x0300
0x0400
385