ds3104-se Maxim Integrated Products, Inc., ds3104-se Datasheet - Page 35

• Manufacturer Part Number: ds3104-se
• Description: Line Card Timing Ic With Synchronous Ethernet Support
• Manufacturer: Maxim Integrated Products, Inc.

Table 7-5. T0 DPLL Adaptation for the T4 DPLL Phase Measurement Mode
Note 1: In this case the T0 select reference must be the same frequency as the T4 selected reference.
Note 2: If the T4 selected reference frequency is 8kHz and the T0 selected reference is a different frequency, the two references can be
compared by configuring the T4 selected reference for 8kHz and LOCK8K mode. This forces the copy of the T0 selected reference to be divided
down to 8kHz using either LOCK8K or DIVN mode.
Note 3: DIVN(8K) means that the FREQ field is set to 8kHz, DIVN(not 8K) means the FREQ field is not set to 8kHz.
7.7.11 Input Jitter Tolerance
The device is compliant with the jitter tolerance requirements of the standards listed in
r360q/r180q PFD, jitter can be tolerated up to the point of eye closure. Either LOCK8K mode (see Section 7.4.2.2)
or the multicycle phase detector (see Section 7.7.5) should be used for high jitter tolerance.
7.7.12 Jitter and Wander Transfer
The transfer of jitter and wander from the selected reference to the output clocks has a programmable transfer
function that is determined by the DPLL bandwidth. (See Section 7.7.3.) In the T0 DPLL, the 3dB corner frequency
of the jitter transfer function can be set to any of 13 positions from 0.1Hz to 400Hz. In the T4 DPLL the 3dB corner
frequency of the jitter transfer function can be set to various values from 18Hz to 70Hz.
During locked mode, the transfer of wander from the local oscillator clock (connected to the REFCLK pin) to the
output clocks is not significant as long as the DPLL bandwidth is set high enough to allow the DPLL to quickly
compensate for oscillator frequency changes. During free-run and holdover modes, local oscillator wander has a
much more significant effect. See Section 7.3.
________________________________________________________________________________________ DS3104-SE
LOCKING MODE
REFERENCE
DIVN (not 8K)
SELECTED
LOCK8K or
LOCK8K or
LOCK8K or
LOCK8K or
DIVN(8K)
DIVN(8K)
DIVN(8K)
DIVN(8K)
DIRECT
FOR T4
MODE FOR T0
DIVN (not 8K)
REFERENCE
SELECTED
LOCKING
DIVN (8K)
LOCK8K
DIRECT
Any
Any
SELECTED REF
COPY OF T0
MODE FOR
LOCKING
LOCK8K
LOCK8K
DIRECT
DIRECT
DIRECT
DIVN
FREQUENCY OF THE
Same as the T4 forced
Same as the T4 forced
FOR T4MT0 PHASE
T4 SELECTED REF
ref input frequency
ref input frequency
MEASUREMENT
8kHz
8kHz
8kHz
8kHz
Table
Same as the T0 selected
Same as the T0 selected
FREQUENCY OF THE
FOR T4MT0 PHASE
T0 SELECTED REF
ref input frequency
ref input frequency
MEASUREMENT
1-1. When using the
8kHz
8kHz
8kHz
8kHz
(1)
(1)
35