z8fmc16100 ZiLOG Semiconductor, z8fmc16100 Datasheet - Page 123

• Manufacturer Part Number: z8fmc16100
• Description: Z8 Encore Motor Control Flash Mcus
• Manufacturer: ZiLOG Semiconductor

PS024611-0408
1
0
1
0
Idle State
Idle State
of Line
of Line
Transmitting Data using Polled Method
Follow the steps below to transmit data using the polled operating method:
1. Write to the LIN-UART Baud Rate High and Low Byte registers to set the appropriate
2. Enable the LIN-UART pin functions by configuring the associated GPIO port pins for
3. If MULTIPROCESSOR mode is appropriate, write to the LIN-UART Control 1
4. Write to the LIN-UART Control 0 register to:
Start
Start
Figure 12. LIN-UART Asynchronous Data Format without Parity
baud rate.
alternate function operation.
register to enable MULTIPROCESSOR (9-bit) mode functions.
Set the MULTIPROCESSOR Mode Select (
mode.
(a) Set the transmit enable bit (
(b) If parity is appropriate and multiprocessor mode is not enabled, set the parity
(c) Set or clear the
Figure 13. LIN-UART Asynchronous Data Format with Parity
Bit 0
enable bit (PEN) and select either even or odd parity (
using the CTS pin.
lsb
Bit 0
lsb
Bit 1
Bit 1
Bit 2
CTSE
Bit 2
bit to enable or disable control from the remote receiver
Bit 3
Data Field
Bit 3
Data Field
TEN
Bit 4
) to enable the LIN-UART for data transmission.
Bit 4
Bit 5
MPEN
Bit 5
Bit 6
Z8FMC16100 Series Flash MCU
) to Enable MULTIPROCESSOR
Transmitting Data using Polled Method
Bit 6
Bit 7
msb
PSEL
Product Specification
Bit 7
msb
).
Parity
Stop Bit(s)
1
Stop Bit(s)
1
2
2
111