PIC18F24J10-E/ML MICROCHIP [Microchip Technology], PIC18F24J10-E/ML Datasheet - Page 31

• Manufacturer Part Number: PIC18F24J10-E/ML
• Description: 28/40/44-Pin High-Performance RISC Microcontrollers with nanoWatt Technology
• Manufacturer: MICROCHIP [Microchip Technology]

2.8
Power-up delays are controlled by two timers, so that
no external Reset circuitry is required for most applica-
tions. The delays ensure that the device is kept in
Reset until the device power supply is stable under nor-
mal circumstances and the primary clock is operating
and stable. For additional information on power-up
delays, see Section 4.5 “Power-up Timer (PWRT)”.
The first timer is the Power-up Timer (PWRT), which
provides a fixed delay on power-up (parameter 33,
Table 23-10). It is always enabled.
TABLE 2-3:
© 2007 Microchip Technology Inc.
EC, ECPLL
HS, HSPLL
Note:
Oscillator Mode
Power-up Delays
See Table 4-2 in Section 4.0 “Reset” for time-outs due to Sleep and MCLR Reset.
OSC1 AND OSC2 PIN STATES IN SLEEP MODE
Floating, pulled by external clock
Feedback inverter disabled at quiescent
voltage level
OSC1 Pin
Preliminary
PIC18F45J10 FAMILY
The second timer is the Oscillator Start-up Timer
(OST), intended to keep the chip in Reset until the
crystal oscillator is stable (HS modes). The OST does
this by counting 1024 oscillator cycles before allowing
the oscillator to clock the device.
There is a delay of interval T
Table 23-10), following POR, while the controller
becomes ready to execute instructions.
At logic low (clock/4 output)
Feedback inverter disabled at quiescent
voltage level
OSC2 Pin
CSD
DS39682C-page 29
(parameter 38,