HD6412332 RENESAS [Renesas Technology Corp], HD6412332 Datasheet - Page 871

• Manufacturer Part Number: HD6412332
• Description: Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2300 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

19.20.10 Notes on Memory Programming
• When programming addresses which have previously been programmed, carry out auto-
• When performing programming using PROM mode on a chip that has been
Notes: 1. The flash memory is initially in the erased state when the device is shipped by Renesas
19.21
Precautions concerning the use of on-board programming mode, the RAM emulation function, and
PROM mode are summarized below.
Use the specified voltages and timing for programming and erasing: Applied voltages in
excess of the rating can permanently damage the device. Use a PROM programmer that supports
the Renesas microcomputer device type with 256-kbyte on-chip flash memory (FZTAT256V3A).
Do not select the HN27C4096 setting for the PROM programmer, and only use the specified
socket adapter. Failure to observe these points may result in damage to the device.
Powering on and off (see figures 19.56 to 19.58): Do not apply a high level to the FWE pin until
V
When applying or disconnecting V
the hardware protection state.
The power-on and power-off timing requirements should also be satisfied in the event of a power
failure and subsequent recovery.
FWE application/disconnection (see figures 19.56 to 19.58): FWE application should be carried
out when MCU operation is in a stable condition. If MCU operation is not stable, fix the FWE pin
low and set the protection state.
CC
erasing before auto-programming.
programmed/erased in an on-board programming mode, auto-erasing is recommended before
carrying out auto-programming.
has stabilized. Also, drive the FWE pin low before turning off V
2. Auto-programming should be performed once only on the same address block.
Flash Memory Programming and Erasing Precautions
Technology. For other chips for which the erasure history is unknown, it is
recommended that auto-erasing be executed to check and supplement the initialization
(erase) level.
Additional programming cannot be carried out on address blocks that have already
been programmed.
CC
power, fix the FWE pin low and place the flash memory in
Rev.4.00 Sep. 07, 2007 Page 841 of 1210
CC
.
REJ09B0245-0400