AT90PWM216-16SE ATMEL [ATMEL Corporation], AT90PWM216-16SE Datasheet - Page 260

• Manufacturer Part Number: AT90PWM216-16SE
• Description: 8-bit Microcontroller with 16K Bytes In-System Programmable flash
• Manufacturer: ATMEL [ATMEL Corporation]

22. Digital to Analog Converter - DAC
22.1
260
Features
AT90PWM216/316
•
•
•
•
•
•
The AT90PWM216/316 features a 10-bit Digital to Analog Converter. This DAC can be used for
the analog comparators and/or can be output on the D2A pin of the microcontroller via a dedi-
cated driver.
This allow to drive (worst case) a 1nF capacitance in parallel with a resistor higher than 33K load
with a time constant around 1us. Response time and power consumption are improved by
reducing the load (reducing the capacitor value and increasing the load resistor value (The best
case is a high impedance)).
The DAC has a separate analog supply voltage pin, AV
0.3V from V
pin.
The reference voltage is the same as the one used for the ADC,
– ADMUX” on page
age reference may be externally decoupled at the AREF pin by a capacitor for better noise
performance.
10 bits resolution
8 bits linearity
+/- 0.5 LSB accuracy between 150mV and AVcc-150mV
Vout = DAC*Vref/1023
The DAC could be connected to the negative inputs of the analog comparators and/or to a
dedicated output driver.
Output impedance around 100 Ohm.
CC
. See the paragraph
249.. These nominally 2.56V Vref or AV
“ADC Noise Canceler” on page 243
CC
. AV
CC
are provided On-chip. The volt-
CC
See “ADC Multiplexer Register
must not differ more than ±
on how to connect this
7710D–AVR–08/09