WM8351CGEB/RV WOLFSON [Wolfson Microelectronics plc], WM8351CGEB/RV Datasheet - Page 49

• Manufacturer Part Number: WM8351CGEB/RV
• Manufacturer: WOLFSON [Wolfson Microelectronics plc]

Production Data
w
The MCLK_SEL bit is used to select the source for SYSCLK. The source may be either directly from
the MCLK input or may be from the output of the FLL. If required, the selected source may be divided
by two, as determined by MCLK_DIV, as described in Table 8. For further details of the FLL, see
Section 12.4.
When the internal clock source is switched from one value to another using MCLK_SEL, the change
of source will only occur following a falling edge of the source signal that was originally selected. In
the case where the clock source is switched from FLL to MCLK, a suitable falling edge can be
ensured by disabling the FLL after selection of MCLK as the source.
The recommended sequence of actions to switch from FLL to MCLK source is as follows:



Note that, as an alternative to the above sequence, a software reset may be used to re-select MCLK
as the default SYSCLK source.
The recommended sequence of actions to switch from MCLK to FLL source is as follows:



Table 8 SYSCLK Control
12.3.1
R40 (28h)
Clock Control
1
REGISTER
ADDRESS
Select MCLK as source (MCLK_SEL = 0)
Disable FLL (FLL_ENA = 0)
Disable FLL oscillator (FLL_OSC_ENA = 0)
Enable FLL oscillator (FLL_OSC_ENA = 1)
Enable FLL (FLL_ENA = 1)
Select FLL as source (MCLK_SEL = 1)
SYSCLK CONTROL
BIT
11
8
MCLK_SEL
MCLK_DIV
LABEL
DEFAULT
0
0
Selects source for SYSCLK to CODEC
0 = MCLK pin
1 = FLL
Selects MCLK division in slave (MCLK
input) mode:
0 = divide MCLK by 1
1 = divide MCLK by 2
DESCRIPTION
PD, April 2012, Rev 4.5
WM8351
49