ATSAM3X4EA-AU Atmel, ATSAM3X4EA-AU Datasheet - Page 132

• Manufacturer Part Number: ATSAM3X4EA-AU
• Description: ARM Microcontrollers - MCU QFP144,GREEN, IND TEMP, MRL A
• Manufacturer: Atmel

Specifications of ATSAM3X4EA-AU

• Rohs: yes
• Core: ARM Cortex M3
• Processor Series: SAM3X
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 84 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 64 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 2.4 V to 3.6 V
• Operating Temperature Range: - 40 C to +85 C
• Package / Case: LQFP-144
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 60

12.15 Saturating instructions
12.15.1
12.15.1.1
12.15.1.2
132
132
SAM3X/A
SAM3X/A
SSAT and USAT
Syntax
Operation
This section describes the saturating instructions, SSAT and USAT.
Signed Saturate and Unsigned Saturate to any bit position, with optional shift before saturating.
where:
op
cond
Rd
n
Rm
shift #s
These instructions saturate to a signed or unsigned n-bit value.
The SSAT instruction applies the specified shift, then saturates to the signed range 2
1
The USAT instruction applies the specified shift, then saturates to the unsigned range
0 x 2
For signed n-bit saturation using SSAT, this means that:
For unsigned n-bit saturation using USAT, this means that:
If the returned result is different from the value to be saturated, it is called saturation. If satura-
tion occurs, the instruction sets the Q flag to 1 in the APSR. Otherwise, it leaves the Q flag
unchanged. To clear the Q flag to 0, you must use the MSR instruction, see
To read the state of the Q flag, use the MRS instruction, see
• if the value to be saturated is less than 2
• if the value to be saturated is greater than 2
• otherwise, the result returned is the same as the value to be saturated.
• if the value to be saturated is less than 0, the result returned is 0
• if the value to be saturated is greater than 2
• otherwise, the result returned is the same as the value to be saturated.
x 2
op{cond} Rd, #n, Rm {, shift #s}
SSAT
USAT
n ranges from 1 to 32 for SSAT
n ranges from 0 to 31 for USAT.
ASR #s where s is in the range 1 to 31
LSL #s where s is in the range 0 to 31.
n–1
n
1.
1.
is one of:
Saturates a signed value to a signed range.
Saturates a signed value to an unsigned range.
is an optional condition code, see
is the destination register.
specifies the bit position to saturate to:
is the register containing the value to saturate.
is an optional shift applied to Rm before saturating. It must be one of the following:
n 1
, the result returned is 2
n 1
n
1, the result returned is 2
“Conditional execution” on page
1, the result returned is 2
“MRS” on page
n-1
n
n-1
1
11057B–ATARM–28-May-12
11057B–ATARM–28-May-12
“MSR” on page
151.
1
100.
152.
n–