ATSAM3X4EA-AU Atmel, ATSAM3X4EA-AU Datasheet - Page 739

• Manufacturer Part Number: ATSAM3X4EA-AU
• Description: ARM Microcontrollers - MCU QFP144,GREEN, IND TEMP, MRL A
• Manufacturer: Atmel

Specifications of ATSAM3X4EA-AU

• Rohs: yes
• Core: ARM Cortex M3
• Processor Series: SAM3X
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 84 MHz
• Program Memory Size: 256 KB
• Data Ram Size: 64 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 2.4 V to 3.6 V
• Operating Temperature Range: - 40 C to +85 C
• Package / Case: LQFP-144
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 60

Notes:
34.10.6
Figure 34-32. Read Write Flowchart in Slave Mode
11057B–ATARM–28-May-12
11057B–ATARM–28-May-12
1. In this case, if TWI_THR has not been written at the end of the read command, the clock is automatically stretched before
2. TXCOMP is only set at the end of the transmission because after the repeated start, SADR is detected again.
Read Write Flowcharts
the ACK.
No
No
SADR + MSDIS + SVEN
Set the SLAVE mode:
Read Status Register
EOSACC = 1 ?
TXCOMP = 1 ?
SVACC = 1 ?
No
END
The flowchart shown in
in Slave mode. A polling or interrupt method can be used to check the status bits. The interrupt
method requires that the interrupt enable register (TWI_IER) be configured first.
GACC = 1 ?
Figure 34-32 on page 739
No
programming sequence
Read TWI_RHR
SVREAD = 0 ?
RXRDY= 0 ?
Decoding of the
Change SADR
Prog seq
OK ?
No
gives an example of read and write operations
No
GENERAL CALL TREATMENT
No
Write in TWI_THR
TXRDY= 1 ?
SAM3X/A
SAM3X/A
No
739
739