HD64F3337YCP16 Renesas Electronics America, HD64F3337YCP16 Datasheet - Page 295

• Manufacturer Part Number: HD64F3337YCP16
• Description: IC H8 MCU FLASH 60K 84PLCC
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300r

Specifications of HD64F3337YCP16

• Core Processor: H8/300
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: Host Interface, I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 74
• Program Memory Size: 60KB (60K x 8)
• Program Memory Type: FLASH
• Ram Size: 2K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 84-PLCC
• Package: 84PLCC
• Family Name: H8
• Maximum Speed: 16 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 8 Bit
• Number Of Programmable I/os: 74
• Interface Type: HIF/I2C/SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 3
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Transmitting Serial Data: Follow the procedure in figure 12.5 for transmitting serial data.
1
2
3
4
If using multiprocessor format,
Write transmit data in TDR
select MPBT value in SSR
Clear TE bit in SCR to 0
Read TDRE bit in SSR
Read TEND bit in SSR
Set DR = 0, DDR = 1
Clear TDRE bit to 0
Serial transmission
Start transmitting
transmission?
Output break
TDRE = 1?
TEND = 1?
Initialize
signal?
End of
End
Figure 12.5 Sample Flowchart for Transmitting Serial Data
Yes
Yes
Yes
Yes
No
No
No
No
1.
2.
3.
4.
(a)
(b)
SCI initialization: the transmit data output function
of the TxD pin is selected automatically.
After the TE bit is set to 1, one frame of 1s is output,
then transmission is possible.
SCI status check and transmit data write: read
the serial status register (SSR), check that the
TDRE bit is 1, then write transmit data in the
transmit data register (TDR) and clear TDRE to 0.
If a multiprocessor format is selected, after
writing the transmit data write 0 or 1 in the
multiprocessor bit transfer (MPBT) in SSR.
Transition of the TDRE bit from 0 to 1 can be
reported by an interrupt.
To continue transmitting serial data: read the
TDRE bit to check whether it is safe to write; if
TDRE = 1, write data in TDR, then clear TDRE
to 0.
To end serial transmission: end of transmission
can be confirmed by checking transition of the
TEND bit from 0 to 1. This can be reported by
a TEI interrupt.
To output a break signal at the end of serial
transmission: set the DDR bit to 1 and clear the
DR bit to 0 (DDR and DR are I/O port registers),
then clear TE to 0 in SCR.
263