MFRC52301HN1,151 NXP Semiconductors, MFRC52301HN1,151 Datasheet - Page 71

• Manufacturer Part Number: MFRC52301HN1,151
• Description: IC MIFARE READER 32-HVQFN
• Manufacturer: NXP Semiconductors
• Series: MIFARE®r

Specifications of MFRC52301HN1,151

• Frequency: 13.56MHz
• Package / Case: 32-VQFN Exposed Pad, 32-HVQFN, 32-SQFN, 32-DHVQFN
• Operating Current: 7 mA
• Operating Voltage: 2.5 V to 3.6 V
• Product: RFID Readers
• Wireless Frequency: 13.56 MHz
• Interface Type: RS-232, I2C
• Data Rate: 100 Kbps
• Operating Temperature Range: - 25 C to +85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Rf Type: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4766; 935282956151; MFRC52301HN1

NXP Semiconductors
MFRC523_32
Product data sheet
PUBLIC
10.3.1.8 Transceive
10.3.1.9 MFAuthent
This command automatically terminates when the data stream ends. This is indicated
either by the end of frame pattern or by the length byte depending on the selected frame
type and speed.
Remark: If the RxModeReg register’s RxMultiple bit is set to logic 1, the Receive
command will not automatically terminate. It must be terminated by starting another
command in the CommandReg register.
This command continuously repeats the transmission of data from the FIFO buffer and the
reception of data from the RF field. The first action is transmit and after transmission the
command is changed to receive a data stream.
Each transmit process must be started by setting the BitFramingReg register’s StartSend
bit to logic 1. This command must be cleared by writing any command to the
CommandReg register.
Remark: If the RxModeReg register’s RxMultiple bit is set to logic 1, the Transceive
command never leaves the receive state because this state cannot be cancelled
automatically.
This command manages MIFARE authentication to enable a secure communication to
any MIFARE Mini, MIFARE 1K and MIFARE 4K card. The following data is written to the
FIFO buffer before the command can be activated:
In total 12 bytes are written to the FIFO.
Remark: When the MFAuthent command is active all access to the FIFO buffer is blocked.
However, if there is access to the FIFO buffer, the ErrorReg register’s WrErr bit is set.
This command automatically terminates when the MIFARE card is authenticated and the
Status2Reg register’s MFCrypto1On bit is set to logic 1.
This command does not terminate automatically if the card does not answer, so the timer
must be initialized to automatic mode. In this case, in addition to the IdleIRq bit, the
TimerIRq bit can be used as the termination criteria. During authentication processing, the
•
•
•
•
•
•
•
•
•
•
•
•
Authentication command code (60h, 61h)
Block address
Sector key byte 0
Sector key byte 1
Sector key byte 2
Sector key byte 3
Sector key byte 4
Sector key byte 5
Card serial number byte 0
Card serial number byte 1
Card serial number byte 2
Card serial number byte 3
Rev. 3.2 — 12 January 2010
115232
Contactless reader IC
MFRC523
© NXP B.V. 2010. All rights reserved.
71 of 98