CV500ETN01 Omron, CV500ETN01 Datasheet - Page 229

• Manufacturer Part Number: CV500ETN01
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500ETN01

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Error Log
204
0103
0105
0107
0108
010B
010D
010E
010F
0110
0111
0112
0117
0118
0119
0120
0121
0122
0123
0124
021A
Error
code
Resend count exceeded (send
failed)
Node address setting error (send
failed)
Remote node not in network (send
failed)
No Unit with specified unit
address (send failed)
CPU Unit error (send failed)
Destination address not in routing
tables (send failed)
No routing table entry (send
failed)
Routing table error (send failed)
Too many relay points (send
failed)
Command too long (send failed)
Header error (send failed)
Internal buffers full; packet dis-
carded
Illegal packet discarded
Local node busy (send failed)
Unexpected routing error
No setting in IP address table;
packet discarded
Service not supported in current
mode; packet discarded
Internal send buffer full; packet
discarded
Maximum frame size exceeded;
routing failed
Logic error in setting table
Meaning
Commands
Bit 15:
Bits 08 to 14: SNA
Bits 00 to 07: SA1
Responses
Bit 15:
Bits 08 to 14: DNA
Bits 00 to 07: DA1
00
1st byte
Detailed error code
OFF
ON
01: Data link
table
02: Network
parameters
03: Routing
tables
04: Unit
Setup
05: CPU Bus
Unit Words
(CIO/DM)
2nd byte
Check transceiver at remote node. ---
Set the IP address correctly.
Check the connection to the
remote node.
Check the unit address at the
remote node.
Troubleshoot the error in the CPU
Unit using the PLC operation
manual.
Set the destination address in the
routing tables.
Set the local node, remote node,
and relay nodes in the routing
tables.
Create the routing tables correctly. ---
Reconstruct the network or cor-
rect the routing tables so that
commands are sent to within a 3-
level network range.
set the correct command data.
set the correct command data.
Change the network so that traffic
is not concentrated.
packets.
Change the network so that traffic
is not concentrated.
Check the routing tables.
Set the remote node in the IP
address table.
Select the IP address table or
both methods for the address con-
version method.
Change the network so that traffic
is not concentrated.
Reduce the size of events.
Recreate the data specified by the
2nd byte of the detailed error
code.
Check the command format and
Check the command format and
Check for nodes sending illegal
Correction
Section 8-3
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
---
Saved
PROM
EE-