CV500ETN01 Omron, CV500ETN01 Datasheet - Page 245

• Manufacturer Part Number: CV500ETN01
• Description: Programmable Logic Controller
• Manufacturer: Omron

Specifications of CV500ETN01

• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Troubleshooting Procedures
Mail Not being Sent
220
information missing from
Is the HOST indicator
Is the HOST indicator
transmission status
transmission status
transmission status
mail address exist?
Does destination
mail content fail
to be obtained?
Is the user mail
Is the user mail
Is the user mail
Did required
S T A R T
Is required
the mail?
E
flashing?
N
N
N
N
N
Y
N
N
"0"?
"6"?
"7"?
lit?
N
D
Y
Y
Y
Y
Y
DNS error status
Is the SMTP,
POP3, or
N
bit ON?
Is the ERH indicator
flashing?
N
Y
Y
N
Y
Y
There is a mistake in the Unit Setup. Correct the mistake.
There is a mistake in the Unit Setup. Correct the mistake.
There is a mistake in the send conditions in the Unit Setup's
mail transmission settings. Correct the mistake.
The mail transmission function cannot be used because no IP
address or host name is set for the SMTP server.
Using the CX-Programmer, make the SMTP settings in the
System Setup. If the host name is used for the server settings,
then the DNS tab settings must be made too.
The mail address set in the Unit Setup is wrong. Correct the
mistake.
Note: Set the destination mail address correctly. If it is incorrect,
Referring to the error log, correct the communications path.
Correct the communications path.
Correct the information in the mail transmission settings in
the Unit Setup.
Clear the following errors.
Unit. Adjust the applications.
The SMTP server address is wrong (set to 255.255.255.255
The SMTP server host name is wrong.
The local mail address is wrong.
The destination mail address is wrong.
The SMTP server address is wrong (set to 0.0.0.0).
The mail transmission settings in the Unit Setup are wrong
The Mail Send Switch never turns ON after a start (power
The interval timer is not set, or is set to an interval longer
The send conditions are not set.
The SMTP server address is wrong.
The IP router table is wrong.
There is a communications error or a mistake in the
If POP before SMTP is required for the SMTP server
The SMTP server address is wrong.
The IP router table is wrong.
There is a communications error or a mistake in the
or 127.*.*.*).
(not set).
ON) or restart.
than intended.
Make the settings for the required user data, error log
If a user-created mail address is wrong, then correct it.
There may be too much of a load (traffic) at the Ethernet
communications path settings.
connection, SMTP (POP before SMTP) and POP must be
set in the Unit Setup.
communications path settings.
data, status data, and file attachments.
mail will stay at the SMTP server.
Section 8-4