XW2Z-200J-B10 Omron, XW2Z-200J-B10 Datasheet - Page 208

• Manufacturer Part Number: XW2Z-200J-B10
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B10

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB10

Pulse Outputs with Acceleration/Deceleration
Pulse Outputs
PULS
INI
Single-phase output
without acceleration/
deceleration
(fixed duty ratio)
Ladder program
1,2,3...
Set the number of
output pulses.
Stop pulse output.
MODE CONTROL
SET PULSES
Refresh status (once each cycle
just after instruction execution)
4. Create the necessary ladder programming.
This procedure shows how to use PULS(886) and ACC(888) to generate a
pulse output with acceleration or deceleration. The number of output pulses
cannot be changed during positioning.
1. Determine pulse output port.
2. Wire the output.
3. Make the necessary System Setup settings (Pulse Output Tab Page − Op-
4. Create the necessary ladder programming.
• Set the clock speed for pulse outputs 1 and 2.
• Use PULS(886) to set number of output pulses for the specified port.
• Use SPED(885) to start pulse output control without acceleration/deceler-
• Use INI(880) to stop pulse output from the specified port.
• Use PRV(881) to read the pulse output PV of the specified port.
• Select pulse output 1 or 2.
• Output: CW and CCW
• Output power supply: 5 V DC
• Set the pulse output operation mode (in the Pulse Output Tab Page −
• Set the clock speed for pulse outputs 1 and 2.
• Use PULS(886) to set number of output pulses for the specified port.
• Use ACC(888) to start pulse output control with acceleration or decelera-
• Use INI(880) to stop pulse output from the specified port.
ation from the specified port.
eration Mode).
Operation Mode) to relative pulse output, absolute linear pulse output, or
absolute circular pulse output.
tion from the specified port (acceleration and deceleration are specified
separately).
Pulse output function
Pulse output status
Port 1
Port 2
SPED
A624
A625
Ladder program
Output mode:
CW/CCW, independent/continuous
Target frequency
Start pulse output
SPEED OUTPUT
Start
output
Refresh PV (once each cycle)
Port 1
Port 2
Pulse output mode
System Setup
Pulse output PV
A621
A623
A620
A622
CCW
CCW
CW
CW
Pulse output
port 1
Pulse output
port 2
Section 7-6
185