XW2Z-200J-B10 Omron, XW2Z-200J-B10 Datasheet - Page 343

• Manufacturer Part Number: XW2Z-200J-B10
• Description: CONNECTOR CABLE 2M
• Manufacturer: Omron

Specifications of XW2Z-200J-B10

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: XW2Z200JB10

Start Code and End Code
Number of Received Bytes
Peripheral Service Time Settings (CX-Programmer: Timer/Peripheral Tab Page)
Fixed Service Time Enable Setting (Set Time to All Events)
Peripheral Service Time
320
System Setup, Auxiliary Area Allocations, and Built-in I/O Allocations
+364
+365
+365
+218
+218
Word
Word
Word
Word
Address
Address
Address
Address
00 to 07 00 to FF hex
08 to 15 00 to FF hex
12
08 and
09
00 to 07 00 hex: 256 bytes
15
00 to 07 00 to FF hex:
Bits
Bits
Bits
Bits
Default: 00 hex
Default: 00 hex
0: Don’t add start code
1: Add start code
Default: 0
00: Don’t add end code and
use number of received bytes
setting
01: Add end code
11: Add CR+LF
Default: 00
01 to FF hex: 1 to 255
Default: 00 hex
0: Default (6.25% of cycle
time)
1: Custom
Default: 0
0.0 to 25.5 ms
(unit: 0.1 ms)
Default: 00 hex
Settings
Settings
Settings
Settings
The frame format
for no-protocol
communications
data (messages)
can be specified.
Specifies whether
the frame format
for no-protocol
communications is
specified.
Specifies the data length to send and
receive for no-protocol communica-
tions. The start code and end code are
not included in the data length.
This setting is valid only when bits 08
and 09 of +365 are set to 00.
The default setting for each TXD(236)/
RXD(235) instruction is 256 bytes. This
setting can be set to 01 to FF to set 255
bytes or less.
Sets the default service time or enables
setting of a custom service time.
Sets the time to allocate to peripheral
servicing. Bit 15 of +218 must be set to
1 to enable this setting.
Function
Function
Function
Function
Specifies the end
code. This setting
is valid when bits
08 to 09 of +365
are set to 01.
Specifies the start
code. This setting
is valid when bit 12
of +365 is set to 1.
Specifies whether
to add a start code.
Specifies whether
to add an end
code.
A414.15 (RS-422A Port
Settings Changing Flag)
A414.15 (RS-422A Port
Settings Changing Flag)
---
---
Related flags and
Related flags and
Related flags and
Related flags and
words
words
words
words
At next cycle (Also
can be changed
with STUP (237).)
At next cycle (Also
can be changed
with STUP (237).)
At start of opera-
tion (cannot be
changed during
operation)
At start of opera-
tion (cannot be
changed during
operation)
Appendix C
When setting is
When setting is
When setting is
When setting is
read
read
read
read