AT32UC3A4128S Atmel Corporation, AT32UC3A4128S Datasheet - Page 381

• Manufacturer Part Number: AT32UC3A4128S
• Manufacturer: Atmel Corporation

Specifications of AT32UC3A4128S

• Flash (kbytes): 128 Kbytes
• Pin Count: 100
• Max. Operating Frequency: 66 MHz
• Cpu: 32-bit AVR
• Hardware Qtouch Acquisition: No
• Usb Transceiver: 1
• Usb Speed: Hi-Speed
• Usb Interface: Device + OTG
• Spi: 6
• Twi (i2c): 2
• Uart: 4
• Sd / Emmc: 2
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: AES
• Sram (kbytes): 128
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0 to 3.6
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

20.4.1
20.4.2
20.4.3
20.5
32072G–11/2011
Functional Description
Module Configuration
Clocks
Interrupts
Most of the features of the GPIO are configurable for each product. The user must refer to the
Package and Pinout chapter for these settings.
Product specific settings includes:
The clock for the GPIO bus interface (CLK_GPIO) is generated by the Power Manager. This
clock is enabled at reset, and can be disabled in the Power Manager.
The CLK_GPIO must be enabled in order to access the configuration registers of the GPIO or to
use the GPIO interrupts. After configuring the GPIO, the CLK_GPIO can be disabled if interrupts
are not used.
The GPIO interrupt lines are connected to the interrupt controller. Using the GPIO interrupt
requires the interrupt controller to be configured first.
The GPIO controls the I/O lines of the microcontroller. The control logic associated with each pin
is represented in the figure below:
• Number of I/O pins.
• Functions implemented on each pin
• Peripheral function(s) multiplexed on each I/O pin
• Reset value of registers
381