AT32UC3L0128 Atmel Corporation, AT32UC3L0128 Datasheet - Page 772

• Manufacturer Part Number: AT32UC3L0128
• Manufacturer: Atmel Corporation

Specifications of AT32UC3L0128

• Flash (kbytes): 128 Kbytes
• Pin Count: 48
• Max. Operating Frequency: 50 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 17
• Hardware Qtouch Acquisition: Yes
• Max I/o Pins: 36
• Ext Interrupts: 36
• Usb Speed: No
• Usb Interface: No
• Spi: 5
• Twi (i2c): 2
• Uart: 4
• Lin: 4
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 12
• Adc Speed (ksps): 460
• Analog Comparators: 8
• Resistive Touch Screen: No
• Temp. Sensor: Yes
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: Yes
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.62 to 3.6
• Operating Voltage (vcc): 1.62 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 6
• Output Compare Channels: 18
• Input Capture Channels: 12
• Pwm Channels: 35
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

31.5.4
31.5.4.1
31.5.4.2
32145A–12/2011
JTAG Data Registers
Device Identification Register
Reset Register
The following device specific registers can be selected as JTAG scan chain depending on the
instruction loaded in the JTAG Instruction Register. Additional registers exist, but are implicitly
described in the functional description of the relevant instructions.
The Device Identification Register contains a unique identifier for each product. The register is
selected by the IDCODE instruction, which is the default instruction after a JTAG reset.
Device specific ID codes
The different device configurations have different JTAG ID codes, as shown in
Note that if the flash controller is statically reset, the ID code will be undefined
Table 31-29. Device and JTAG ID
The reset register is selected by the AVR_RESET instruction and contains one bit for each reset
domain in the device. Setting each bit to one will keep that domain reset until the bit is cleared.
Bit
Device ID
Revision
Part Number
Manufacturer ID
Device Name
AT32UC3L0256
AT32UC3L0128
System
31
MSB
Revision
4 bits
This is a 4 bit number identifying the revision of the component.
Rev A = 0x0, B = 0x1, etc.
The part number is a 16 bit code identifying the component.
The Manufacturer ID is a 11 bit code identifying the manufacturer.
The JTAG manufacturer ID for ATMEL is 0x01F.
Resets the whole chip, except the JTAG itself.
JTAG ID Code (R is the revision number)
0xR21C903F
0xR21CA03F
28
27
Part Number
Bit
Reset
domain
16 bits
12
11
System
0
AT32UC3L0128/256
Manufacturer ID
11 bits
.
1
Table
LSB
1 bit
31-29.
0
1
772