AM79C976 Advanced Micro Devices, AM79C976 Datasheet - Page 96
![no-image](/images/manufacturer_photos/0/0/14/advanced_micro_devices_sml.jpg)
AM79C976
Manufacturer Part Number
AM79C976
Description
PCnet-PRO 10/100 Mbps PCI Ethernet Controller
Manufacturer
Advanced Micro Devices
Datasheet
1.AM79C976.pdf
(309 pages)
- Current page: 96 of 309
- Download datasheet (3Mb)
tests on the external SRAM, internal SRAM access
logic, and the PC board interconnect.
The MBIST controller can determine the size of the ex-
ternal SRAM and verify its operation using the following
procedure:
1. Program SRAM_SIZE to the minimum allowed
2. Write DM_START and DM_FAIL_STOP (write
3. Read DM_DONE (DATAMBIST
4. If DM_ERROR is set, the memory is defective; re-
5. Program SRAM_SIZE to the maximum value of
6. If DM_ERROR is zero, report the current value of
7. If DM_ERROR is set, program SRAM_SIZE to one-
8. Repeat, using the binary search algorithm, until the
EEPROM Interface
The Am79C976 device includes an interface to an op-
tional 16-bit word-oriented 93Cxx-compatible serial
EEPROM that supports automatic address increment-
ing (sequential read). This EEPROM can be used for
storing initial values for Am79C976 registers. The con-
tents of this EEPROM are automatically loaded into the
selected registers after a reset operation or whenever
the host CPU requests an EEROM read operation.
Note that if the EEPROM is not included in the system,
the MAC address (and Magic Packet information, if
needed) must be initialized by the host CPU.
The Am79C976 device automatically detects the size
of the EEPROM. When the EEPROM decodes a read
command, it drives its DO pin low when the A0 address
bit is written to the DI pin. The Am79C976 device uses
this fact to detect the number of bits in the EEPROM
address and from this determines the EEPROM size.
Data in the EEPROM are interpreted as three-byte
entries that contain register address and register data
so that the system designer can choose which regis-
ters will automatically be loaded. In a typical system,
the EEPROM would be used to initialize the device’s
IEEE 802 physical address, the PCI Subsystem Vendor
ID, LED configuration, SSRAM configuration, and other
hardware configuration information. For compatibility
96
value of 4.
DATAMBIST bits 63:56 with 0x28). The remainder
of the DATAMBIST register ignores writes so it may
be written with arbitrary data or not written at all.
DM_ERROR (DATAMBIST bit 62) until DM_DONE
is set.
port the error and exit.
0x8000 and repeat steps 2 and 3.
SRAM_SIZE as the SSRAM size.
half the maximum (0x4000) and repeat steps 2
and 3.
SRAM size has been determined.
bit 63)
P R E L I M I N A R Y
and
Am79C976
with older PCnet family software the Address PROM
Space should be loaded from the EEPROM. See the
Address PROM Space section for details.
Only the memory-mapped registers can be loaded
from the EEPROM. While the CSRs and BCRs are not
memory-mapped, all useful bits in the CSRs and BCRs
are aliased into memory-mapped registers so that all
useful bits can be loaded from the EEPROM.
Most of the memory-mapped registers are 32 bits wide
and occupy 4 bytes of memory space each. For exam-
ple, the CMD2 Register is located at offset 50h from the
memory base address. Its least significant 16 bits can
be accessed at offset 50h, and its most significant 16
bits can be accessed at offset 52h. Register data are
loaded from the EEPROM 16 bits at a time, so that the
high order bits of a register are loaded independently
from the low order bits.
The EEPROM Access Register gives the host CPU di-
rect access to the interface pins so that it can read from
or write to the EEPROM.
After the trailing edge of the RESET signal or after the
PREAD bit in BCR19 is set, the Am79C976 device be-
gins to read data from the EEPROM. Data from the EE-
PROM are interpreted as a string of 3-byte entries.
Each entry contains a 1-byte register address and a
2-byte register data field. The register address field
contains the offset of the target register divided by 2.
The initialization logic writes the contents of the register
data field into the register selected by the register ad-
dress byte.
Since EEPROM data are loaded two bytes at a time,
the least significant bit of the target register offset is
omitted from the address field. Only bits 8:1 are in-
cluded. Therefore, the register address byte contains
the offset of the target register divided by two. For ex-
ample, the Control2 Register (CTRL2) is a 32-bit regis-
ter located at offset 70h (relative to the contents of the
Memory-Mapped I/O Base Address Register). There-
fore, the byte stream 38h, 02h, 05h would cause the
value 0205h to be loaded into bits [15:0] of CTRL2, and
39h, 00h, 03h would cause the value 0003h to be
loaded into bits [31:16] of the same register.
If the value of the address byte is 0FFh, the following
2-byte field is interpreted as a 16-bit CRC code rather
than as register data. The CRC code covers all
EEPROM data up to and including the address byte of
the entry containing the CRC. All EEPROM data after
the CRC code word are ignored.
The CRC code used is CRC-16, which is based on the
generator polynomial x
The EEPROM must contain data for an odd number of
registers so that the CRC is aligned on a 16-bit word
16
+ x
15
+ x
2
+ 1.
8/01/00
Related parts for AM79C976
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![AM27S29DC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Advanced Micro Devices [4,096-Bit (512x8) Bipolar PROM]
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM27S29APC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Advanced Micro Devices [4,096-Bit (512x8) Bipolar PROM]
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM29BL802CB-70RZE](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Advanced Micro Devices [8 Megabit (512 K x 16-Bit) CMOS 3.0 Volt-only Burst Mode Flash Memory]
Manufacturer:
Advanced Micro Devices
Datasheet:
![M41000001Y](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
M41000001YAdvanced Micro Devices [32 Megabit (4 M x 8-Bit/2 M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Operation Flash Memory and 4 Mbit (512 K x 8-Bit/256 K x 16-Bit) Static RAM]
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM95C94JC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Advanced Burst Error Processor
Manufacturer:
Advanced Micro Devices
![AM7992BPC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Serial interface adapter (SIA)
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM9519ADC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Universal interrupt controller
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM27C256-150DC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
256 kilobit CMOS EPROM
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM9128-10PC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
2048 x 8 static RAM, 100ns
Manufacturer:
Advanced Micro Devices
Datasheet:
![P8284A](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Manufacturer:
Advanced Micro Devices
Datasheet:
![DM81LS98N](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Three-State Octal Buffers
Manufacturer:
Advanced Micro Devices
Datasheet:
![AM2966PC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
AM2966PCOctal Dynamic Memory Drivers with Three-State Outputs
Manufacturer:
Advanced Micro Devices
Datasheet:
![DM81LS97N](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Three-State Octal Buffers
Manufacturer:
Advanced Micro Devices
Datasheet:
![DM81LS96N](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
Three-State Octal Buffers
Manufacturer:
Advanced Micro Devices
Datasheet:
![PAL16L8-7PC](/images/manufacturer_photos/0/0/14/advanced_micro_devices_tmb.jpg)
Part Number:
Description:
TTL programmable array logic, 7ns
Manufacturer:
Advanced Micro Devices
Datasheet: