STEVAL-IFS006V1 STMicroelectronics, STEVAL-IFS006V1 Datasheet - Page 123

• Manufacturer Part Number: STEVAL-IFS006V1
• Description: BOARD EVAL 8BIT MICRO + TDE1708
• Manufacturer: STMicroelectronics

Specifications of STEVAL-IFS006V1

• Design Resources: STEVAL-IFS006V1 Bill of Material
• Sensor Type: Proximity
• Interface: I²C
• Voltage - Supply: 6 V ~ 48 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FLITEUS5, TDE1708
• Processor To Be Evaluated: ST7LITEUS5
• Data Bus Width: 8 bit
• Operating Supply Voltage: 6 V to 48 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: TDE1708DFT
• Kit Application Type: Sensing - Touch / Proximity
• Application Sub Type: Proximity Switch
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-6403; STEVAL-IFS006V1

ST7LITEUS2, ST7LITEUS5
14
14.1
14.1.1
Device configuration and ordering information
Each device is available for production in user programmable versions (FLASH) as well as in
factory coded versions (FASTROM). Refer to
numbers:
●
●
The FASTROM factory coded parts contain the code supplied by the customer. This implies
that FLASH devices have to be configured by the customer using the Option Bytes while the
FASTROM devices are factory-configured.
Option bytes
The two option bytes allow the hardware configuration of the microcontroller to be selected.
The option bytes can be accessed only in programming mode (for example using a standard
ST7 programming tool).
OPTION BYTE 1
ST7FLITEUSA2xx and ST7FLITEUSA5xx XFlash devices are shipped to customers
with a default program memory content (FFh).
Factory Advanced Service Technique ROM (FASTROM) versions are also available:
they are factory-programmed XFlash devices.
Bits 3:2 LVD[1:0] Low Voltage Detection selection
Bit 7:6 CKSEL[1:0] Startup clock selection.
Bit 5 Reserved, must always be 1.
Bit 4 Reserved, must always be 0.
Bit 1 WDG SW Hardware or software watchdog
Bit 0 WDG HALT Watchdog Reset on Halt
This bit is used to select the startup frequency. By default, the internal RC is
selected (see
These option bits enable the LVD block with a selected threshold as shown in
Table 76: LVD threshold
This option bit selects the watchdog type.
0: Hardware (watchdog always enabled)
1: Software (watchdog to be enabled by software)
This option bit determines if a reset is generated when entering Halt mode while the
watchdog is active.
0: No Reset generation when entering Halt mode
1: Reset generation when entering Halt mode
Table 75: Startup clock
configuration.
Device configuration and ordering information
Table 79
selection).
for the full list of supported part
123/136