STEVAL-IFS006V1 STMicroelectronics, STEVAL-IFS006V1 Datasheet - Page 124

• Manufacturer Part Number: STEVAL-IFS006V1
• Description: BOARD EVAL 8BIT MICRO + TDE1708
• Manufacturer: STMicroelectronics

Specifications of STEVAL-IFS006V1

• Design Resources: STEVAL-IFS006V1 Bill of Material
• Sensor Type: Proximity
• Interface: I²C
• Voltage - Supply: 6 V ~ 48 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FLITEUS5, TDE1708
• Processor To Be Evaluated: ST7LITEUS5
• Data Bus Width: 8 bit
• Operating Supply Voltage: 6 V to 48 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: TDE1708DFT
• Kit Application Type: Sensing - Touch / Proximity
• Application Sub Type: Proximity Switch
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-6403; STEVAL-IFS006V1

Device configuration and ordering information
14.1.2
124/136
Table 75.
Table 76.
OPTION BYTE 0
Table 77.
Internal RC as Startup Clock
Reserved
AWU RC as a Startup Clock
Reserved
External Clock on pin PA5
LVD Off
Highest voltage threshold
Medium voltage threshold
Lowest voltage threshold
Bits 7:4 Reserved, must always be 1.
Bit 3 Reserved, must always be 0.
Bit 2 SEC0 Sector 0 size definition
Bit 1 FMP_R Readout protection
Bit 0 FMP_W FLASH write protection
Startup clock selection
LVD threshold configuration
Definition of sector 0 size
Sector 0 Size
This option bit indicates the size of sector 0 according to the following table (see
Table 77: Definition of sector 0
Readout protection, when selected provides a protection against program memory
content extraction and against write access to Flash memory. Erasing the option
bytes when the FMP_R option is selected will cause the whole memory to be
erased first, and the device can be reprogrammed. Refer to
ST7 Flash Programming Reference Manual for more details.
0: Readout protection off
1: Readout protection on
This option indicates if the FLASH program memory is write protected.
Warning: When this option is selected, the program memory (and the option bit
itself) can never be erased or programmed again.
0: Write protection off
1: Write protection on
0.5k
1k
Configuration
Configuration
size).
CKSEL1
SEC0
ST7LITEUS2, ST7LITEUS5
0
1
0
0
0
1
1
Section 4.5
LVD1
1
1
0
0
CKSEL0
and the
0
0
1
0
1
LVD0
1
0
1
0