DEMO9S08JM16 Freescale Semiconductor, DEMO9S08JM16 Datasheet - Page 299

• Manufacturer Part Number: DEMO9S08JM16
• Description: BOARD DEMO FOR JM16 FAMI
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08JM16

• Contents: Board with Daughter card, Cable, Documentation, Mini-AB USB Kit
• Processor To Be Evaluated: MC9S08JM16
• Data Bus Width: 8 bit
• Interface Type: USB
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: Flexis - S08JM
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08JM16
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

17.1.6
Figure 17-2
Freescale Semiconductor
Mode
Stop3
Wait
24 MHz Clock (bus clk)
48 MHz Reference Clock
Block Diagram
is a block diagram of the USB module.
The USB module is optionally available in stop3.
A reduced current consumption mode may be required for USB suspend mode per USB Specification Rev. 2.0,
and stop3 mode is useful for achieving lower current consumption for the MCU and hence the overall USB
device. Before entering stop3 via firmware, the user must ensure that the device settings are configured for
stop3 to achieve USB suspend current consumption targets.
The USB module is notified about entering suspend mode when the SLEEPF flag is set; this occurs after the
USB bus is idle for 3 ms. The device USB suspend mode current consumption level requirements are defined
by the USB Specification Rev. 2.0 (500 μA for low-power and 2.5 mA for high-power with remote-wakeup
enabled).
If USBRESMEN in USBCTL0 is set, and a K-state (resume signaling) is detected on the USB bus, the LPRESF
bit in USBCTL0 will be set. This triggers an asynchronous interrupt that will wakeup the MCU from stop3 mode
and enable clocks to the USB module. The USBRESMEN bit must then be cleared immediately after stop3
recovery to clear the LPRESF flag bit.
USB module is operational.
IRQ
USB CONTROLLER
Table 17-2. Operating Modes (continued)
Figure 17-2. USB Module Block Diagram
MC9S08JM16 Series Data Sheet, Rev. 2
USB RAM
256 bytes
Description
Serial Interface Engine
(SIE)
Initiator
Target
BVCI
BVCI
Protocol and Rate
Match
Universal Serial Bus Device Controller (S08USBV1)
Logic
Logic
RX
TX
Enable
USBDP Pullup
XCVR
VREG
V
USBDN
USBDP
USB33
299