DV007004 Microchip Technology, DV007004 Datasheet - Page 104

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

DS51464C-page 98
®
9.4.2
Once a device is selected, the device’s menu is displayed:
• Program Verify Device (see Section 8.5.1 “Program Verify Device”)
• Verify Device (see Section 8.5.2 “Verify Device”)
• All Functions
When the MPLAB PM3 Card is inserted, the All Functions option displays a submenu
with the selections listed in Table 9-1. Note that there is an additional option for the
MPLAB PM3 Card at the end of the list. For all other functions listed, refer to
Section 8.5.3 “All Functions”.
TABLE 9-1:
The MPLAB PM3 Card function displays these options:
TABLE 9-2:
Read Device
Program Verify Device
Verify Device
Blank Check Device
Erase Device
Device Information
MPLAB PM3 Card
Settings
Load an Environment
View an Environment
Card Properties
Selection
All Functions Menu
ALL FUNCTIONS MENU
MPLAB
®
PM3 CARD FUNCTIONS
Loads the Environment into the MPLAB PM3 programmer
from the MPLAB PM3 Card
The View an Environment option displays the contents
and settings of an Environment. You can only view the
Environment using this option.
Displays the card’s byte capacity, bytes free, bytes used
and byte cluster
Reads the device content. Selective read (e.g., part of program
memory, only Configuration bits of the device) can be done by
setting up Settings below.
Programs and verifies the device.
Verifies that the device was programmed properly.
Checks that the device is completely blank (all bits are set to ‘1’).
This will also check that all Configuration bits are set to ‘1’
(unprogrammed state).
Erases the device in the MPLAB
option displays only for erasable devices.
Displays the device name, Device ID, Device Revision, Last
Checksum and the User IDs.
Displays a submenu of operations that pertain to the MPLAB
PM3 Card.
Sets up program/verify options, ICSP™ settings, adjust voltages,
reset voltages, reset statistics count and Safe mode.
.
Description
®
PM3 device programmer. This
© 2006 Microchip Technology Inc.