DV007004 Microchip Technology, DV007004 Datasheet - Page 88

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

8.5
DS51464C-page 82
COMMAND MENU
®
After a device is selected, the device programmer displays the Command menu:
• Program Verify Device
• Verify Device
• All Functions
The functions on the Command menu allow you to perform the basic user tasks for
programming a microcontroller device. Pressing <ESC> repeatedly will return you to
the Main menu.
8.5.1
The Program Verify Device option erases (if Flash device), programs and verifies the
device (see Section 8.5.3.7 “Settings”).
8.5.2
The Verify Device option verifies that the device was programmed properly.
8.5.3
The All Functions option displays a submenu with the selections listed in Table 8-1:
TABLE 8-1:
8.5.3.1
If you want to copy firmware from a programmed device into an unprogrammed device,
you can read the programmed firmware into MPLAB PM3 memory, then program the
new device based on this information. Select “Read Device” to copy the contents of the
device in the socket module into the internal memory of the device programmer.
For PIC16CXX devices, the device programmer will ask the question: “Code Protect
Parts?” Answer “Yes” to code-protect the parts that you will be programming. Code
protection will remain effective until a new device is read. Answer “No” to program
devices exactly as read.
After reading a device, the device programmer displays a checksum. If the device is
code-protected, a code protection message will be displayed prior to the read. Answer
“Yes” to continue. Answer “No” to return to the Command menu.
Read Device
Program Verify Device
Verify Device
Blank Check Device
Erase Device
Device Information
Settings
Selection
Program Verify Device
Verify Device
All Functions
READ DEVICE
ALL FUNCTIONS MENU
Reads the device content. Selective read (e.g., part of program
memory, only Configuration bits of the device) can be done by
setting up Settings below.
Programs and verifies the device.
Verifies that the device was programmed properly.
Checks that the device is completely blank (all bits are set to ‘1’).
This will also check that all Configuration bits are set to ‘1’
(unprogrammed state).
Erases the device in the MPLAB
option displays only for erasable devices.
Displays the device name, Device ID, Device Revision, Last
Checksum and the User IDs.
Sets up program/verify options, ICSP™ settings, adjust voltages,
reset voltages, reset statistics count and safe mode.
Description
®
PM3 device programmer. This
© 2006 Microchip Technology Inc.