DV007004 Microchip Technology, DV007004 Datasheet - Page 70

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

DS51464C-page 64
®
Certain voltages may be viewed/set for Flash devices (see Table 7-5) and Non-Flash
devices (see Table 7-6). Other voltages are applicable to both types of devices (see
Table 7-7). For Information on changing voltage settings and using low voltage pro-
gramming, see Section 7.5.2.1 “Changing Voltage Settings” and
Section 7.5.2.2 “Using Low Voltage Program”, respectively.
TABLE 7-5:
TABLE 7-6:
TABLE 7-7:
V
V
V
V
V
Reset Voltages
Low Voltage Program
Power Target Circuit from
MPLAB PM3
PP
DD
DD
DD
DD
A
Min
Max
Nom
PP
Selection
Selection
Selection
FLASH DEVICES
NON-FLASH DEVICES
ALL DEVICES
This is the voltage used by the programmer to verify Flash
memory. The default is the device's nominal voltage value.
This voltage and
verify memory in EEPROM devices. The value should be the
minimum voltage for the designated circuit. The default is the
device's minimum voltage value.
This voltage and
verify memory. The value should be the maximum voltage for
the designated circuit. The default is the device's maximum
voltage value.
This is the voltage at which the device is programmed. This
should be the average voltage at which the system will run.
The default is 5 volts.
This is the voltage used to bring the device into a program-
ming mode. Although this is dependent of the device's
programming specification, it may be changed. If “Low
Voltage Program” is selected, this is changed to
by the programmer.
Resets all voltages to their default values.
In ICSP™ mode, select this checkbox to perform Low Volt-
age programming. Low Voltage programming uses a dedi-
cated pin to enter into the programming mode versus a high
voltage on V
installed.
In ICSP mode, this allows the target circuit to be powered
from MPLAB PM3 to supply power for programming. This
check box is ignored when a socket is installed.
PP
. This check box is ignored when a socket is
V
V
DD
DD
Max are used by the programmer to
Min are used by the programmer to
Description
Description
Description
© 2006 Microchip Technology Inc.
V
DD
Nom