DV007004 Microchip Technology, DV007004 Datasheet - Page 19

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

© 2006 Microchip Technology Inc.
2.3.1.1
• Connect one end of the USB cable to a USB port on your PC.
• Connect the cable from the PC USB port to the corresponding USB connector on
2.3.1.2
• Connect one end of the RS-232 cable to an available COM port on your PC.
• Connect the cable from the PC COM port to corresponding RS-232 connector on
2.3.2
MPLAB PM3 comes with a proprietary external power supply.
1. Make sure that the power switch on the back of the unit is in the OFF position
2. Plug the power supply into a power socket and connect the power supply cable
the back of MPLAB PM3.
Check your PC setup to see which communications port is available.
the back of MPLAB PM3. For more on serial connections, see
Section A.2 “Connecting to a PC via the Serial Port”.
IMPORTANT: Set the COM port FIFO buffers off, the Flow Control to “Hardware” and
Baud Rate to 57600. You will need to reboot your PC for these settings to take effect.
See Section B.5.2.5 “Manually Setting Up The Port” for more information.
Note:
(see Figure 2-1).
to the unit.
FOR USB COMMUNICATIONS
FOR RS-232 COMMUNICATIONS
Installing the Power Supply
If you are using USB and a “New Hardware Detected” notice appears on
your PC, you must follow the directions on installing the proper driver or
your MPLAB PM3 will not work.
NOTICE
DS51464C-page 13