DV007004 Microchip Technology, DV007004 Datasheet - Page 74

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

DS51464C-page 68
®
7.5.4.2
To use USB communications between the PC and the MPLAB PM3 device
programmer, select the
FIGURE 7-7:
To make sure the port is set up properly, follow the instructions in the “For USB
Communications” subsection in Section 2.3.1 “Installing the Communications
Cable”.
7.5.4.3
If MPLAB PM3 is enabled in one mode of communication (USB or serial) and you wish
to switch to the other mode, do the following:
1. Deselect the programmer in MPLAB IDE (Programmer>Select
2. Turn the MPLAB PM3 programmer off and physically change the
3. Turn the MPLAB PM3 programmer back on.
4. Reselect the programmer (Programmer>Select Programmer>MPLAB PM3).
5. Select the other mode of communication (Programmer>Settings,
6. Enable the programmer (Programmer>Enable Programmer).
Do not allow the Windows OS to pick a USB driver. Follow the procedure specified
in Section 2.2 “Installing MPLAB PM3 Software”.
Programmer>None).
communications cable connection. If not already done, install the proper drivers.
Communications tab).
USB COMMUNICATIONS
SWITCHING THE COMMUNICATION MODE
USB PORT
USB
port
(Figure 7-7). Click OK.
CAUTION
© 2006 Microchip Technology Inc.