DV007004 Microchip Technology, DV007004 Datasheet - Page 50

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

DS51464C-page 44
®
4.8.2
The ICSP (In-Circuit Serial Programming) socket is an extension of the MPLAB PM3
device programmer that allows you to program PICmicro microcontroller devices that
are already installed in the target board.
MPLAB PM3 comes equipped with an ICSP header and cable. You can locate this con-
nector under where a socket module would be installed. See Section A.4 “ICSP Hard-
ware Specifications” for header and cable pinout information.
To program a device using ICSP:
1. Select Programmer>Settings and click the Voltages tab.
2. In the “ICSP Options” area, select “Low Voltage Program” to program using this
FIGURE 4-5:
3. Connect the ICSP cable connector to the ICSP socket on MPLAB PM3.
4. Connect the necessary cables to the header on your target board. Refer to
5. Program the device. See Section 4.5 “Programming a Device”.
Note:
method. Be sure to connect the LVP/PGM pin and Enable the Low Voltage Pro-
gram Configuration bit if the Low Voltage Program option has been selected.
Select “Power target circuit from MPLAB PM3” if you want to power the circuit
through MPLAB PM3 instead of using power from the target board (Figure 4-5).
Table A-3 in Appendix A. “Hardware Specifications” for cable pins, colors and
signals.
ICSP Programming
For information on how to program a specific device using ICSP, consult the
programming specification for that device. See the README for MPLAB
PM3 for a list of programming specifications of supported devices.
Programming specifications may also be found on the Microchip web site
at www.microchip.com.
ICSP™ OPTIONS
© 2006 Microchip Technology Inc.