DV007004 Microchip Technology, DV007004 Datasheet - Page 43

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

4.1
4.2
4.3
4.4
© 2006 Microchip Technology Inc.
INTRODUCTION
BEFORE YOU BEGIN
MPLAB PM3 DIALOGS
SETUP FOR PROGRAMMING A DEVICE
Chapter 4. Using MPLAB PM3 with MPLAB IDE
This chapter describes the main steps in programming and reading a device using the
MPLAB PM3 device programmer. Topics covered in this chapter include:
• Before You Begin
• MPLAB PM3 Dialogs
• Setup for Programming a Device
• Programming a Device
• Verifying the Programming
• Reading a Device
• Special Programming
Before using MPLAB PM3, you must have performed the following initialization steps:
1. Installed the MPLAB IDE software (Section 2.2 “Installing MPLAB PM3
2. Turned the power on MPLAB PM3 (Section 2.4 “Powering Up MPLAB PM3”).
3. Selected MPLAB PM3 as your programmer (Section 2.5.2 “Selecting MPLAB
4. Configured the communications port that MPLAB IDE will use to communicate
5. Selected the device you wish to program from the list of available devices
6. Enabled (started) the MPLAB PM3 programmer (Section 2.5.5 “Enabling
The MPLAB PM3 Programmer Menu options are displayed when the programmer is
enabled. If the option is unavailable, the item appears in gray (not black) text.
The next section will discuss how these dialogs are used to program devices.
To program a device, you will need:
• A hex file to program into the device.
• A device to program. Must be blank if non-flash device.
(See Section 7.4.7 “Blank Check All”.)
Software”) and MPLAB PM3 hardware (Section 2.3 “Installing MPLAB PM3
Hardware”).
PM3 as the Programmer”).
with MPLAB PM3 (Section 2.5.3 “Setting Up the Communications Port”).
(Section 2.5.4 “Selecting a Device in MPLAB IDE”).
MPLAB PM3”).
USER’S GUIDE
MPLAB
DS51464C-page 37
®
PM3