DV007004 Microchip Technology, DV007004 Datasheet - Page 112

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

DS51464C-page 106
®
A.5.4.2
The expected life for manual insertions has been found to be less than the manufac-
turer’s reported number. The number of manual insertions depends on the socket
condition and how often the socket is cleaned.
Careless insertions or dirty socket conditions can bring the number of insertions down
to less than 5,000. Cleanliness and care in inserting devices into a socket are most
important with surface mount devices because the socket contacts must remain
planar to function properly.
Any bent or nonplanar contacts will result in a failure. Nonplanar socket module
contacts occur earlier in the life of a socket module when devices are inserted manually
into a socket module. Early contact failure from manual insertions is due to the non
repeatability of the manual insertion method. Therefore, the listed number of insertions
might not be reached for sockets if devices are inserted manually. No good method
exists to ensure that the contacts are planar.
A.5.4.3
Clean with methyl alcohol, then blow off the contacts with dry compressed air.
A.5.5
Table A-12 shows typical programming times for MPLAB PM3 when used in
Stand-Alone mode. Results may vary when programming through MPLAB IDE.
TABLE A-12:
Methyl alcohol is highly flammable. Use methyl alcohol in a well ventilated area
away from sparks, flames or any other source of ignition. Methyl alcohol is
poisonous and may cause blindness if taken internally. Avoid inhaling methyl
alcohol vapor.
INSERTIONS
CLEANING METHOD – METHYL ALCOHOL
Typical Programming Times
PIC16F877A
PIC18F8720
PIC16C55A
PIC12C509
PIC12F675
PIC16F819
PIC18F452
PIC16F877
TYPICAL PROGRAMMING TIMES IN STAND-ALONE MODE
PIC16F88
PIC17C44
PIC16F77
Device
DANGER
Programming Time
© 2006 Microchip Technology Inc.
3.7 seconds
2.5 seconds
6.6 seconds
37 seconds
10 seconds
24 seconds
4 seconds
5 seconds
4 seconds
7 seconds
4 seconds