DV007004 Microchip Technology, DV007004 Datasheet - Page 73

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

© 2006 Microchip Technology Inc.
7.5.4
To set the port for communications between the programmer and the PC, select
Programmer>Settings and click on the Communications tab. Communications
between the programmer and the PC may be either over a serial connection or a USB
connection.
The Windows COM port setup requires special attention. The proper drivers must be
installed and the port may need to be set up manually. For additional information on the
communication port setup, refer to Section 2.3.1 “Installing the Communications
Cable”, Section 2.5 “Configuring MPLAB IDE for Use with MPLAB PM3” and
B.5.1 “Failure to Establish Communication with Programmer”.
7.5.4.1
To use RS-232 (serial) communications between the PC and the MPLAB PM3 device
programmer, select the
COM1 is the default. Click OK.
FIGURE 7-6:
To make sure the port is set up properly, follow the instructions in the “For RS-232
Communications” subsection in Section 2.3.1 “Installing the Communications
Cable”.
Note:
Communications Tab
SERIAL COMMUNICATION
Do not physically connect both.
SERIAL COM PORT
PC COM
port for use:
COM1, COM2, COM3 or COM4 (Figure 7-6).
DS51464C-page 67