DV007004 Microchip Technology, DV007004 Datasheet - Page 18

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

2.3
DS51464C-page 12
INSTALLING MPLAB PM3 HARDWARE
®
2.2.2
Install MPLAB IDE first. The USB driver installation instructions will pop up at the end
of MPLAB IDE installation. Follow those instructions to install the USB driver.
The instructions are in the MPLAB IDE installation directory under:
MPLAB PM3\Drivers\instr.htm
where instr.htm depends on your Personal Computer (PC) OS:
• ddpm398.htm – Windows 98
• ddpm3me.htm – Windows ME
• ddpm3.htm – Windows 2000/XP
IMPORTANT: Do not allow the Windows OS to pick a USB driver. Follow the procedure
specified in Section 2.2.2 “USB Driver Installation”.
The MPLAB PM3 hardware is simple to set up:
• If you are using MPLAB IDE:
• If you are using MPLAB PM3 in Stand-Alone mode:
• If you are using the MPLAB PM3 Card in MPLAB PM3:
2.3.1
MPLAB PM3 provides communications with the host PC via an RS-232 9-pin D type
connector or a USB connector. See Figure 2-1 for communication port locations.
MPLAB PM3 is supplied with two 6-foot data cables: one with DB-9 connectors and one
with USB connectors. All lines on the serial cable are wired straight through. The serial
cable is NOT a null modem cable.
FIGURE 2-1:
- Attach the communications cable.
- Connect the power supply to MPLAB PM3.
- Install the socket module (or attach the ICSP cable).
- Connect the power supply to MPLAB PM3.
- Install the socket module or attach the ICSP cable.
- Insert the MPLAB PM3 Card into the SD-MMC port on the back of the
Do not allow the Windows OS to pick a USB driver. MPLAB PM3 will not work with
this driver. You must follow the procedure specified at MPLAB IDE software installa-
tion to set up the USB driver or to fix an improper driver installation.
PWR
programmer.
Power Input
USB Driver Installation
Installing the Communications Cable
Power On Power Off
I
BACK VIEW OF MPLAB
O
USB
USB Port
NOTICE
RS-232
®
PM3
Serial Port
© 2006 Microchip Technology Inc.
Multi-Media Card Port
Secure Digital/
SD-MMC