DV007004 Microchip Technology, DV007004 Datasheet - Page 121

• Manufacturer Part Number: DV007004
• Description: PROGRAMMER UNIVERSAL PM3
• Manufacturer: Microchip Technology
• Series: MPLAB&reg PM3r
• Type: Universalr

Specifications of DV007004

• Contents: MPLAB PM3 Programming Unit, Cables, Power Supply and IDE
• Positions/sockets: 1
• Ic Product Type: Programmer, Universal
• Supported Families: PICmicro, DsPIC30F
• Kit Contents: LCD, ICSP Support, 40-pin Socket, Digital/Multimedia Card Slot
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: Microchip's PICmicro devices including dsPIC30F
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With: PICmicro And DsPIC30F DSC Devices
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

© 2006 Microchip Technology Inc.
TABLE B-2:
Code
Error
10
12
13
14
15
16
17
18
19
20
24
25
26
27
11
1
2
3
4
5
6
7
8
9
CPLD is Not Configured
CPLD is Old
Flash is Missing
Flash is Crossed Incorrectly
FPGA Configuration has
Time-out
FPGA Image is Missing
FPGA is Old
Power Monitor is Not Found
Power Monitor is Old
ICSP™ Monitor is Not Found
ICSP Monitor is Old
Failure on the Daughter Board
USB is Not Found
USB is Old
Display was Not Found
Memory Failure
OS is Not Found
V
V
OS is Old
Clock is Missing
Display Read Write Failure
Power Monitor Can Not Ramp
Up Voltages
Updating Failed
DD
PP
is Over Current
is Over Current
BIOS ERROR CODES
Definition
Reset and connect to MPLAB
Reset and connect to MPLAB IDE.
Reset the unit. If the problem persists, contact
your field representative to SAR the unit.
Reset the unit. If the problem persists, contact
your field representative to SAR the unit.
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset the unit. If the problem persists, contact
your field representative to SAR the unit
Reset and connect to MPLAB IDE.
Reset and connect to MPLAB IDE.
Reset the unit. If the problem persists, contact
your field representative to SAR the unit
Reset the unit. If the problem persists, contact
your field representative to SAR the unit
Reset and connect to MPLAB IDE.
If programming using a socket module, verify
that the proper part is selected and the part is
inserted in the socket properly.
If programming using a socket module, verify
that the proper part is selected and the part is
inserted in the socket properly.
Reset and connect to MPLAB IDE.
Reset the unit. If the problem persists, contact
your field representative to SAR the unit
Reset the unit. If the problem persists, contact
your field representative to SAR the unit
Ensure the target is disconnected from
MPLAB PM3 and retry. If it passes, check the
ICSP wiring. If it fails again, contact your field
representative to SAR the unit.
Turn unit off. Check connections to PC. Make
sure the appropriate port is selected and the
proper drivers are installed. Restart and retry.
Corrective Action
®
DS51464C-page 115
IDE.