SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 544

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

• CPCDIS: Counter Clock Disable with RC Compare
0 = counter clock is not disabled when counter reaches RC.
1 = counter clock is disabled when counter reaches RC.
• EEVTEDG: External Event Edge Selection
• EEVT: External Event Selection
Note:
• ENETRG: External Event Trigger Enable
0 = the external event has no effect on the counter and its clock. In this case, the selected external event only controls the
TIOA output.
1 = the external event resets the counter and starts the counter clock.
• WAVSEL: Waveform Selection
• WAVE
0 = Waveform Mode is disabled (Capture Mode is enabled).
1 = Waveform Mode is enabled.
546
0
0
1
1
0
0
1
1
0
1
0
1
1. If TIOB is chosen as the external event signal, it is configured as an input and no longer generates waveforms and subse-
EEVTEDG
WAVSEL
SAM9G10
EEVT
quently no IRQs.
0
1
0
1
0
1
0
1
0
0
1
1
Edge
none
rising edge
falling edge
each edge
Signal selected as external event
TIOB
XC0
XC1
XC2
Effect
UP mode without automatic trigger on RC Compare
UP mode with automatic trigger on RC Compare
UPDOWN mode without automatic trigger on RC Compare
UPDOWN mode with automatic trigger on RC Compare
input
TIOB Direction
output
output
output
(1)
6462B–ATARM–6-Sep-11