SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 83

no-image

SAM9G10

Manufacturer Part Number
SAM9G10
Description
Manufacturer
Atmel Corporation
Datasheets

Specifications of SAM9G10

Flash (kbytes)
0 Kbytes
Pin Count
217
Max. Operating Frequency
266 MHz
Cpu
ARM926
Hardware Qtouch Acquisition
No
Max I/o Pins
96
Ext Interrupts
96
Usb Transceiver
3
Usb Speed
Full Speed
Usb Interface
Host, Device
Spi
2
Twi (i2c)
1
Uart
4
Ssc
3
Sd / Emmc
1
Graphic Lcd
Yes
Video Decoder
No
Camera Interface
No
Resistive Touch Screen
No
Temp. Sensor
No
Crypto Engine
No
Sram (kbytes)
16
Self Program Memory
NO
External Bus Interface
1
Dram Memory
sdram
Nand Interface
Yes
Picopower
No
Temp. Range (deg C)
-40 to 85
I/o Supply Class
1.8/3.3
Operating Voltage (vcc)
1.08 to 1.32
Fpu
No
Mpu / Mmu
No/Yes
Timers
3
Output Compare Channels
3
Input Capture Channels
3
32khz Rtc
Yes
Calibrated Rc Oscillator
No
13.10.3.1
13.10.3.2
6462B–ATARM–6-Sep-11
Enumeration Process
Communication Endpoints
Atmel provides an INF example to see the device as a new serial port and also provides another
custom driver used by the SAM-BA application: atm6124.sys. Refer to the document “USB Basic
Application”, literature number 6123, for more details.
The USB protocol is a master/slave protocol. This is the host that starts the enumeration send-
ing requests to the device through the control endpoint. The device handles standard requests
as defined in the USB Specification.
Table 13-3.
The device also handles some class requests defined in the CDC class.
Table 13-4.
Unhandled requests are STALLed.
There are two communication endpoints and endpoint 0 is used for the enumeration process.
Endpoint 1 is a 64-byte Bulk OUT endpoint and endpoint 2 is a 64-byte Bulk IN endpoint. SAM-
BA Boot commands are sent by the host through the endpoint 1. If required, the message is split
by the host into several data payloads by the host driver.
If the command requires a response, the host can send IN transactions to pick up the response.
Request
GET_DESCRIPTOR
SET_ADDRESS
SET_CONFIGURATION
GET_CONFIGURATION
GET_STATUS
SET_FEATURE
CLEAR_FEATURE
Request
SET_LINE_CODING
GET_LINE_CODING
SET_CONTROL_LINE_STATE
Handled Standard Requests
Handled Class Requests
Definition
Returns the current device configuration value.
Sets the device address for all future device access.
Sets the device configuration.
Returns the current device configuration value.
Returns status for the specified recipient.
Used to set or enable a specific feature.
Used to clear or disable a specific feature.
Definition
Configures DTE rate, stop bits, parity and number of
character bits.
Requests current DTE rate, stop bits, parity and number of
character bits.
RS-232 signal used to tell the DCE device the DTE device
is now present.
SAM9G10
83

Related parts for SAM9G10