SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 593

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

36.3
36.3.1
36.3.2
36.3.3
6462B–ATARM–6-Sep-11
Product Dependencies
I/O Lines
Power Management
Interrupt
DPs and DMs are not controlled by any PIO controllers. The embedded USB physical transceiv-
ers are controlled by the USB host controller.
The USB host controller requires a 48 MHz clock. This clock must be generated by a PLL with a
correct accuracy of ± 0.25%.
Thus the USB device peripheral receives two clocks from the Power Management Controller
(PMC): the master clock MCK used to drive the peripheral user interface (MCK domain) and the
UHPCLK 48 MHz clock used to interface with the bus USB signals (Recovered 12 MHz domain).
The USB host interface has an interrupt line connected to the Advanced Interrupt Controller
(AIC).
Handling USB host interrupts requires programming the AIC before configuring the UHP.
SAM9G10
595