SAM9G10 Atmel Corporation, SAM9G10 Datasheet - Page 77

• Manufacturer Part Number: SAM9G10
• Manufacturer: Atmel Corporation

Specifications of SAM9G10

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 266 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Ssc: 3
• Sd / Emmc: 1
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: No
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 16
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.08 to 1.32
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

13.4.2.1
13.5
6462B–ATARM–6-Sep-11
Serial Flash Boot
Example
Figure 13-5. Structure of the ARM Vector 6
An example of valid vectors follows:
The size of the image to load into SRAM is contained in the location of the sixth ARM vector.
Thus the user must replace this vector by the correct size of his application.
The Serial Flash boot looks for a valid application in the SPI SerialFlash memory.
SPI0 is configured in master mode to generate a SPCK at 8MHz. Serial Flash shall be con-
nected to NPCS0.
The SerialFlash boot reads the serial flash status register (Instruction code 0x05). The serial
flash is considered as ready if bit 0 of the returned status register is cleared.
If no serial flash is connected or if it does not answer, SerialFlash boots exits after a 1000
attempts.
If the serial flash is ready, Serial Flash boot reads the first 8 words into SRAM (Instruction code
“Continuos read array” 0x0b) and checks if it corresponds to valid exception vectors according to
the Valid Image detection algorithm.
If a valid application is found, this application is loaded into internal SRAM and executed by
branching at address 0x0000_0000 after remap. This application may be the application code or
a second-level bootloader.
31
00
04
08
0c
10
14
18
ea000006
eafffffe
ea00002f
eafffffe
eafffffe
00001234
eafffffe
B
B
B
B
B
B
B
0x20
0x04
_main
0x0c
0x10
0x14
0x18
Size of the code to download in bytes
<- Code size = 4660 bytes
SAM9G10
0
77