S1D13505 Epson Electronics America, Inc., S1D13505 Datasheet - Page 331

• Manufacturer Part Number: S1D13505
• Description: LCD Controller
• Manufacturer: Epson Electronics America, Inc.

Epson Research and Development
Vancouver Design Center
Comments
Program Messages
13505PWR Software Suspend Power Sequencing Utility
Issue Date: 01/02/02
• The /i argument is to be used when the registers have not been previously initialized.
• When using a PC with the S5U13505 evaluation board, the PC must not have more than 12M
• GPIO1 is used to signal when the software suspend mode, hardware suspend mode, or LCD has
• Hardware suspend is changed by reading or writing to a memory address decoded by the PAL on
ERROR: Did not detect S1D13505.
The HAL was unable to read the revision code register on the S1D13505. Ensure that the S1D13505
hardware is installed and that the hardware platform has been set up correctly.
ERROR: Unknown command line argument.
An invalid command line argument was entered. Enter a valid command line argument.
ERROR: Already selected SOFTWARE.
Command line argument /softwar e was selected more than once. Select /software only once.
ERROR: Already selected HARDWARE.
Command line argument /hardware was selected more than once. Select /hardware only once.
ERROR: Already selected LCD.
Command line argument /lcd was selected more than once. Select /lcd only once.
ERROR: Already selected ENABLE.
Command line argument /enable was selected more than once. Select /enable only once.
ERROR: Already selected DISABLE.
Command line argument /disable was selected more than once. Select /disable only once.
ERROR: Select /software, /hardware or /lcd.
Did not select one of the following command line arguments: /software, /hardware or /lcd .
Select /software , /hardware or /lcd.
ERROR: Select /enable or /disable.
Neither command line argument /enable or /disable was selected. Select /enable or
/disable
bytes of system memory.
been enabled or disabled.
the S5U13505 evaluation board. This PAL is currently only used for PC platforms, so the
S5U13505 evaluation board does not support hardware suspend on embedded platforms.
.
X23A-B-007-03
S1D13505
Page 5