HD6417020SVX12I Renesas Electronics America, HD6417020SVX12I Datasheet - Page 171

• Manufacturer Part Number: HD6417020SVX12I
• Description: IC SUPERH MPU ROMLESS 100TQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7020r

Specifications of HD6417020SVX12I

• Core Processor: SH-1
• Core Size: 32-Bit
• Speed: 12.5MHz
• Connectivity: EBI/EMI, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 32
• Program Memory Type: ROMless
• Ram Size: 1K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-TQFP, 100-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

Table 8.10 Refresh and Bus Cycle Contention
Type of
Refresh
CAS-before-
RAS refresh
Self-refresh
Yes: Can be executed in parallel
No: Cannot be executed in parallel
When parallel execution is available, the RAS and CAS signals are output simultaneously during
bus cycle execution and the refresh is executed. When parallel execution is not available, refresh
occurs after the bus cycle has ended.
Using RTCNT as an 8-Bit Interval Timer: When not performing refresh control, RTCNT can be
used as an 8-bit interval timer. Simply set the RFSHE bit of the RCR to 0. To produce a compare
match interrupt (CMI), set the compare match interrupt enable bit (CMIE) to 1 and set the
interrupt generation timing in RTCOR. When the input clock is selected with the CKS2–CKS0
bits of the RTCSR, RTCNT starts incrementing as an 8-bit interval timer. Its value is constantly
being compared to RTCOR and when a match occurs, the CMF bit of RTCSR is set to 1 and a
CMI interrupt is produced. RTCNT is cleared to H'00.
When the clock is selected with CKS2–CKS0 bits, RTCNT starts incrementing immediately. This
means that when the RTCOR cycle is set after the CKS2–CKS0 bits are set, the RTCNT count
may already be higher than the RTCOR cycle. When this occurs, the RTCNT will overflow once
(H'FF goes to H'00) and the count up will start again. No interrupt will be generated until the
RTCNT again matches the RTCOR value. It is thus advisable to set the RTCOR cycle prior to
setting the CKS2–CKS0 bits. After its use as an 8-bit interval timer, the RTCNT count value may
be in excess of the set cycle. For this reason, write H'00 to the RTCNT to clear it before starting to
use it again with new settings. RTCNT can then be restarted and an interrupt obtained after the
correct interval.
8.6
The BSC is equipped with a function that multiplexes input/output of address and data to pins
AD15–AD0 in area 6. This allows the SH microprocessor to be directly connected to peripheral
LSIs that required address/data multiplexing.
Address/Data Multiplexed I/O Space Access
Read Cycle Write Cycle Read Cycle Write Cycle Peripheral Access
Yes
Yes
External Memory Space,
Multiplexed I/O Space
No
Yes
External Space Access
No
No
Type of Bus Cycle
DRAM Space
No
No
On-Chip ROM, On-Chip
RAM , On-Chip
Yes
Yes
RENESAS 151