UJA1066TW/5V0,518 NXP Semiconductors, UJA1066TW/5V0,518 Datasheet - Page 21

• Manufacturer Part Number: UJA1066TW/5V0,518
• Manufacturer: NXP Semiconductors

Specifications of UJA1066TW/5V0,518

• Number Of Transceivers: 1
• Power Down Mode: Sleep/Standby
• Standard Supported: ISO 11898-2
• Operating Supply Voltage (min): 5.5V
• Operating Temperature (max): 125C
• Operating Temperature (min): -40C
• Operating Temperature Classification: Automotive
• Mounting: Surface Mount
• Lead Free Status / RoHS Status: Compliant

NXP Semiconductors
UJA1066_2
Product data sheet
6.7.1.2 On-line mode
6.7.1.3 On-line Listen mode
6.7.1.4 Off-line mode
6.7.2 CAN wake-up
In On-line mode the CAN-bus pins and pin SPLIT (if enabled) are biased to the normal
levels. The CAN transmitter is deactivated and RXDC reflects the CAN wake-up status. A
CAN wake-up event is signalled to the microcontroller by clearing RXDC.
If the bus stays continuously dominant or recessive for the Off-line time (t
Off-line state will be entered.
On-line Listen mode is similar to On-line mode, but all activity on the CAN-bus, with the
exception of a special global wake-up request, is ignored. The global wake-up request is
described in
Off-line mode is the low-power mode of the CAN transceiver. The CAN transceiver is
disabled to save supply current and is high-ohmic terminated to ground.
The CAN off-line time is programmable in two steps with the CAN Off-line Timer Control
(COTC) bit. When entering On-line (Listen) mode from Off-line mode the CAN off-line time
is temporarily extended to t
To wake-up the UJA1066 via CAN it is necessary to distinguish between a conventional
wake-up and a global wake-up in case partial networking is enabled (bit CPNC = 1).
A dominant, recessive, dominant, recessive signal on the CAN-bus is needed to pass the
wake-up filter for a conventional wake-up; see
For a global wake-up from On-line Listen mode, two distinct CAN data patterns are
required:
The second pattern must be received within t
CAN-ID can be used with these data patterns.
If the CAN transceiver enters On-line Listen mode directly from Off-line mode, the global
wake-up message is sufficient to wake-up the SBC. This pattern must be received within
t
message is received, then both messages are required for a CAN wake-up.
timeout
•
•
In the initial message: C6 - EE - EE - EE - EE - EE - EE - EF (hexadecimal values)
In the global wake-up message: C6 - EE - EE - EE - EE - EE - EE - 37 (hexadecimal
values)
after entering On-line Listen mode. Should t
Section
All information provided in this document is subject to legal disclaimers.
6.7.2. Pin RXDC is held HIGH.
Rev. 03 — 17 March 2010
off-line(ext)
.
High-speed CAN fail-safe system basis chip
timeout
Figure
timeout
after receiving the first pattern. Any
9.
elapse before the global wake-up
UJA1066
© NXP B.V. 2010. All rights reserved.
off-line
), the
21 of 70