MT29F1G08ABADAWP-IT:D Micron Technology Inc, MT29F1G08ABADAWP-IT:D Datasheet - Page 35

no-image

MT29F1G08ABADAWP-IT:D

Manufacturer Part Number
MT29F1G08ABADAWP-IT:D
Description
Manufacturer
Micron Technology Inc
Datasheet

Specifications of MT29F1G08ABADAWP-IT:D

Lead Free Status / Rohs Status
Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MT29F1G08ABADAWP-IT:D
Manufacturer:
PULSE
Quantity:
15 650
Part Number:
MT29F1G08ABADAWP-IT:D
Manufacturer:
ST
0
Part Number:
MT29F1G08ABADAWP-IT:D
Manufacturer:
MICRON/美光
Quantity:
20 000
Part Number:
MT29F1G08ABADAWP-IT:D
Quantity:
1 100
Part Number:
MT29F1G08ABADAWP-IT:D
0
READ PARAMETER PAGE (ECh)
Figure 26: READ PARAMETER (ECh) Operation
PDF: 09005aef83e5ffed
m68a.pdf – Rev. D 06/10 EN
Cycle type
I/O[7:0]
R/B#
Command
ECh
The READ PARAMETER PAGE (ECh) command is used to read the ONFI parameter
page programmed into the target. This command is accepted by the target only when
all die (LUNs) on the target are idle.
Writing ECh to the command register puts the target in read parameter page mode. The
target stays in this mode until another valid command is issued.
When the ECh command is followed by an 00h address cycle, the target goes busy for
t
the READ MODE (00h) command must be used to re-enable data output mode.
A minimum of three copies of the parameter page are stored in the device. Each param-
eter page is 256 bytes. If desired, the RANDOM DATA READ (05h-E0h) command can be
used to change the location of data output.
R. If the READ STATUS (70h) command is used to monitor for command completion,
Address
00h
t WB
t R
t RR
35
D
P0
OUT
0
Micron Technology, Inc. reserves the right to change products or specifications without notice.
D
P1
1Gb x8, x16: NAND Flash Memory
OUT
0
READ PARAMETER PAGE (ECh)
D
OUT
D
P0
OUT
1
© 2010 Micron Technology, Inc. All rights reserved.
D
P1
OUT
1
D
OUT

Related parts for MT29F1G08ABADAWP-IT:D