DS33R11+ Maxim Integrated Products, DS33R11+ Datasheet - Page 18

• Manufacturer Part Number: DS33R11+
• Description: IC ETH TXRX T1/E1/J1 256-BGA
• Manufacturer: Maxim Integrated Products
• Type: Transceiverr

Specifications of DS33R11+

• Protocol: T1/E1/J1
• Voltage - Supply: 1.8V, 3.3V
• Mounting Type: Surface Mount
• Package / Case: 256-BGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Drivers/receivers: -

4 ACRONYMS AND GLOSSARY
•
•
•
•
•
•
•
•
•
Note 1: Previous versions of this document used the term “Subscriber” to refer to the Ethernet Interface function.
The register names have been allowed to remain with a “SU.” prefix to avoid register renaming.
Note 2: Previous versions of this document used the term “Line” to refer to the Serial Interface. The register names
have been allowed to remain with a “LI.” prefix to avoid register renaming.
Note 3: The terms “Transmit Queue” and “Receive Queue” are with respect to the Ethernet Interface. The Receive
Queue is the queue for the data that arrives on the MII/RMII interface, is processed by the MAC and stored in the
SDRAM. Transmit queue is for data that arrives from the Serial port, is processed by the HDLC and stored in the
SDRAM to be sent to the MAC transmitter.
Note 4: This data sheet assumes a particular nomenclature of the T1 operating environment. In each 125μs frame
there are 24 8-bit channels plus a framing bit. It is assumed that the framing bit is sent first followed by channel 1.
Each channel is made up of eight bits that are numbered 1 to 8. Bit number 1 is the MSB and is transmitted first.
Bit number 8 is the LSB and is transmitted last. The term “locked” is used to refer to two clock signals that are
phase- or frequency-locked or derived from a common clock (i.e., a 1.544MHz clock can be locked to a 2.048MHz
clock if they share the same 8kHz component). Throughout this data sheet, the following abbreviations are used:
B8ZS
BOC
CRC
D4
ESF
FDL
FPS
Fs
Ft
HDLC
MF
SLC–96
BERT: Bit Error-Rate Tester
DCE: Data Communication Interface
DTE: Data Terminating Interface
FCS: Frame Check Sequence
HDLC: High-Level Data Link Control
MAC: Media Access Control
MII: Media Independent Interface
RMII: Reduced Media Independent Interface
WAN: Wide Area Network
Bipolar with 8 Zero Substitution
Bit-Oriented Code
Cyclical Redundancy Check
Superframe (12 frames per multiframe) Multiframe Structure
Extended Superframe (24 frames per multiframe) Multiframe Structure
Facility Data Link
Framing Pattern Sequence in ESF
Signaling Framing Pattern in D4
Terminal Framing Pattern in D4
High-Level Data Link Control
Multiframe
Subscriber Loop Carrier—96 Channels
18 of 344